Summary of Contents for W Audio RM 30BP
- Page 1 RM 30T Twin UHF Handheld Radio Microphone System (863.1Mhz/864.8Mhz) User Manual Order code: MIC66...
-
Page 2: Safety Advice
Safety advice Safety advice WARNING FOR YOUR OWN SAFETY, PLEASE READ THIS USER MANUAL CAREFULLY BEFORE YOUR INITIAL START-UP! • Before your initial start-up, please make sure that there is no damage caused during transportation. • Should there be any damage, consult your dealer and do not use the equipment. • To maintain the equipment in good working condition and to ensure safe operation, it is necessary for the user to follow the safety instructions and warning notes written in this manual. • Please note that damages caused by user modifications to this equipment are not subject to warranty. CAUTION! CAUTION! KEEP THIS EQUIPMENT TAKE CARE USING AWAY FROM MOISTURE, THIS EQUIPMENT! RAIN AND LIQUIDS, AND HIGH VOLTAGE-RISK OUT OF DAMP/HUMID... - Page 3 Product overview & technical specifications RM 30T Twin UHF Handheld Radio Microphone System The RM 30T Series of wireless microphones are designed for numerous • 2 x XLR outputs plus applications, including vocals and public address. With several handy • 1 x 6.35mm jack mixed output features they are ideal both on stage or at home. Compact and robust • 6.35mm (1/4”) jack to jack design allows them to withstand the stresses of the road making them patch cable perfect for entertainers and amateurs alike. • UK mains PSU Foam lined, Supplied in a foam lined case. The hand held systems flexibility can be ABS carry case further enhanced by the addition of the RM 30 Belt Pack Kit. Twin UHF handheld radio microphone system featuring a robust metal receiver and a dual antenna system. Each mic requires 2 x 1.5V AA batteries not supplied. Specifications RM 30T UHF Radio Microphone System In the box: Operating frequency 863.1Mhz/864.8Mhz 1 x receiver, 1 x audio lead, Power supply DC 12-15V, 500mA (adaptor supplied) 2 x wireless microphones,...
- Page 4 Operating instructions Receiver panel identification: 4. Display 7. DC Power Input 1. Power Switch The receiver features a backlit display The receiver is powered by a standard On/Off control for the system receiver. allowing the user to see the fixed RF DC power input 12-18V DC, 300mA 3. RF Signal Indicator frequency. regulated voltage supply. The LED RF Signal indicator will 5. Volume Controls 8. Balanced Audio Output B illuminate amber when the receiver The receivers output volume is Individual, balanced audio outputs unit receives a valid RF radio signal. adjustable for each of the two audio via 3 pin XLR for audio channel B. Each channel features an independent channels. Turn the level control anti RF indicator. 9. Balanced Audio Output A clockwise to the lowest setting, or 2. Audio Indicator Individual, balanced audio outputs turn clockwise to adjust to the highest via 3 pin XLR for audio channel A. The LED Audio indicator will illuminate setting. Each channel features an green to show when the audio signal 10. Audio (MIX) Output independent volume control. received by the receiver. Each channel 6.35mm (1/4”) jack socket outputting 6. Antenna features an independent audio...
-
Page 5: Operation
Operating instructions Handheld transmitter Operation: identification: • Carefully, lift the antennae into the vertical position. 1. Grille • Connect the included power supply to a suitable 240V AC~50Hz 2. Display mains voltage outlet and plug the DC connector into the DC 3. Battery cover Power Input on the rear panel of the receiver (12-18V DC, 4. Power indicator 500mA minimum). on base • Using the supplied audio cable, connect the MIX OUT on the rear 5. Power switch panel of the receiver for both audio channels to the mixer’s audio on base line input. The receiver also features balanced XLR outputs, one for each channel. • Switch on the power to the receiver, checking the display backlight illuminates. • Open the battery compartment on the transmitter (Optional Beltpack – slide downwards away from the belt clip. Handheld - unscrew the lower portion). Install the appropriate batteries into the transmitter, taking care to observe the orientation and polarity. Only use high quality, alkaline type batteries. Refit the battery compartment cover carefully. • Switch on the transmitter, during switch on the battery light on the transmitter illuminate. If the light does illuminate or glows dimly, the battery will require replacement. • Adjust the volume on the front panel of the receiver for each of the channels. -
Page 6: Optional Accessories
Optional accessories Optional RM 30BP UHF Beltpack Add On Kits Add-on package suitable for use with the RM 30 and RM 30T UHF microphone systems. The RM 30BP Belt Pack Kit comes Specifications RM 30BP UHF Beltpack Add On KIts supplied with a belt pack transmitter, headset microphone and Operating frequency 863.1Mhz 864.8Mhz lavalier microphone which allow the user to interchange one or Battery type 2 x 1.5V AA (not supplied) more of the handheld microphones from the RM 30 and RM Order code MIC67 MIC68 30T systems, thus increasing the flexibility of the system. Beltpack transmitter identification: 1. Audio input connector 2. Volume knob 3. Transmitting antenna 4. Power switch 5. LED display 6. Low power indicator... -
Page 7: Weee Notice
WEEE notice Correct Disposal of this Product (Waste Electrical & Electronic Equipment) (Applicable in the European Union and other European countries with separate collection systems) This marking shown on the product or its literature, indicates that it should not be disposed of with other household wastes at the end of its working life. To prevent possible harm to the environment or human health from uncontrolled waste disposal, please separate this from other types of wastes and recycle it responsibly to promote the sustainable reuse of material resources. Household users should contact either the retailer where they purchased this product, or their local government office, for details of where and how they can take this item for environmentally safe recycling. Business users should contact their supplier and check the terms and conditions of the purchase contract. This product should not be mixed with other commercial wastes for disposal. www.prolight.co.uk RM 30T User Manual... - Page 8 www.prolight.co.uk RM 30T User Manual...