Contents Safety information Daily use Safety instructions Hints and tips Product description Care and cleaning Control panel Troubleshooting Programmes Technical information Settings GREAT BRITAIN – Customer Care and Service Before first use Subject to change without notice. Safety information Before the installation and use of the appliance, carefully read the supplied instructions.
Obey the maximum number of 13 place settings. • If the supply cord is damaged, it must be replaced by the manufacturer, its • Authorised Service Centre or similarly qualified persons in order to avoid a hazard. Put the cutlery in the cutlery basket with the sharp ends pointing down or •...
from the mains socket. Contact the Authorised • When you contact the Authorised Service Centre, Service Centre to replace the water inlet hose. ensure that you have the following information that is available on the rating plate. Model : PNC : •...
Upper basket Control panel On/off button Programme button Programme indicators Indicators Indicators Indicator Description End indicator. Salt indicator. It is always off while the programme operates. Programmes Programme Degree of soil Programme phases Consumption values Type of load Duration Energy Water (min) (kWh)
Programme Degree of soil Programme phases Consumption values Type of load Duration Energy Water (min) (kWh) • Wash 60 °C or Fresh soil 65 °C Crockery and cut- • Rinses lery • Prewash 1) The pressure and the temperature of the water, the variations of the mains supply, the options and the quantity of dishes can change the values.
How to deactivate AirDry The appliance must be in programme selection mode. 1. To enter the user mode, press and hold the programme button until the indicator flashes and indicators are on. 2. Press the programme button twice. • The indicators are on.
Caution! Only use rinse aid specifically designed for dishwashers. 1. Press the release button (D) to open the lid (C). 2. Pour the rinse aid in the dispenser (A) until the liquid reaches the fill level 'max'. 3. Remove the spilled rinse aid with an absorbent cloth to prevent too much foam.
Using the multi-tablets the programme duration. After closing the door, the appliance continues from the point of interruption. When you use tablets, that contain salt and rinse aid, do not fill the salt container and the rinse aid dispenser. If the door is opened for more than 30 seconds during the drying phase, the 1.
• Detergent tablets do not fully dissolve with short • Put hollow items (cups, glasses and pans) with the programmes. To prevent detergent residues on the opening down. tableware, we recommend that you use the tablets • Make sure that glasses do not touch other glasses. with long programmes.
Page 12
7. Reassemble the filters (B) and (C). 8. Put back the filter (B) in the flat filter (A). Turn it clockwise until it locks. 2. Remove the filter (C) out of filter (B). 3. Remove the flat filter (A). 4. Wash the filters. Caution! An incorrect position of the filters can cause bad washing results and damage to the appliance.
cleaning product for dishwashers. Follow carefully the instructions on the packaging of the product. Troubleshooting If the appliance does not start or it stops during With some problems the end indicator flashes operation, before you contact an Authorised Service intermittently indicating a malfunction. Centre, check if you can solve the problem by yourself The majority of problems that can occur can be with the help of the information in the table.
Page 14
Problem and alarm code Possible cause and solution • The tableware is not properly arranged in the baskets. Refer Rattling/knocking sounds from inside the appli- to basket loading leaflet. ance. • Make sure that the spray arms can rotate freely. •...
Problem Possible cause and solution • This is not a defect of the appliance. it is caused by the humidity in the The interior of the appliance is wet. air that condenses on the walls. • Use the detergent for dishwashers only. Unusual foam during washing.
Power consumption Left-on mode (W) Power consumption Off-mode (W) 0.50 1) Refer to the rating plate for other values. 2) If the hot water comes from alternative source of energy, (e.g. solar panels, aeolian energy), use the hot water supply to decrease energy consumption.
Need help?
Do you have a question about the IDSH604W and is the answer not in the manual?
Questions and answers