Table of Contents
Advertisement
TROUBLESHOOTING
WARNING! Refer to Safety chapters.
WHAT TO DO IF...
Problem
The cooking zones do not op-
erate.
You cannot activate or operate
the oven. The display shows
"400" and an acoustic signal
sounds.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The lamp does not operate.
Steam and condensation settle
on the food and in the cavity of
the oven.
The display shows "12.00".
SERVICE DATA
If you cannot find a solution to the problem yourself,
contact your dealer or an Authorised Service
Centre.
The necessary data for the service centre is on the
rating plate. The rating plate is on the front frame of
Model (MOD.)
Product number (PNC)
Serial number (S.N.)
Possible cause
Refer to the operating instructions for the built-in cooking surface.
The oven is incorrectly connec-
ted to an electrical supply.
The oven is deactivated.
The clock is not set.
The necessary settings are not
set.
The fuse is blown.
The lamp is defective.
You left the dish in the oven for
too long.
There was a power cut.
We recommend that you write the data here:
Check if the oven is correctly
connected to the electrical
supply (refer to the connection
diagram if available).
Activate the oven.
Set the clock.
Make sure that the settings are
correct.
Make sure that the fuse is the
cause of the malfunction. If the
fuse is blown again and again,
contact a qualified electrician.
Replace the lamp.
Do not leave the dishes in the
oven for longer than 15 - 20
minutes after the cooking
process ends.
Reset the clock.
the appliance cavity. Do not remove the rating plate
from the appliance cavity.
.........................................
.........................................
.........................................
Remedy
17
Advertisement
Table of Contents
