Page 1
I NSTALLATION
I NSTRUCTIONS
2009-2012 RAM Truck Rear Vision Parkline Camera with RCA and Factory Display Harnesses (Kit part number FLTW-7634) Kit Contents: Tools & Supplies Required: Chassis Harness...
Page 2
7. Disengage (2) plastic Latch Rod Retainer Clips using 13. Reattach (2) plastic Latch Rod Retainer Clips using your fingers. (Figure 2) your fingers. 14. Reattach Tailgate Access Panel. Figure 2 15. (If equipped), reinstall plastic Tailgate Protector. 16. Close Tailgate. Chassis Harness Pass Through 17.
Page 3
Figure 7 Figure 12 25. Connect supplied Chassis Harness to Tailgate Handle Recommended: Apply a corrosion inhibitor to the Camera harness. Use supplied glued heat shrink Chassis Harness pass through hole. (Figure 8) tube over RCA and Power connector to create seal Figure 8 between chassis and camera harness.
Page 4
31. Use a Plastic Trim Tool to remove shifter bezel and Remove ½” remove two screws from under the rubber mat using bolt attaching a Phillips screwdriver. Instrument 32. Use a Plastic Trim Tool to remove cup holder bezel. Panel 33.
Page 5
D. Using the scan tool select the VEHICLE PREPARATION and then select RESTORE VEHICLE CONFIGURATION. E. Follow the step by step instructions on the scan tool to complete the Park View Rear Back-Up Camera vehicle configuration. 48. Reconnect negative battery terminal 49.