M.2 Solid-State Drive - HP ProBook 450 G5 Maintenance And Service Manual

M.2 solid-state drive

Description
512-GB, Turbo Drive
256-GB, PCIe
128-GB, SATA-3
Before removing the solid-state drive, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Place the computer in "Battery Safe mode"
3. Disconnect all external devices connected to the computer.
4. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
5. Remove the main service door
6. Remove the drive service door
Remove the solid-state drive:
1. Remove the Phillips M2.0×3.0 screw (1) that secures the solid-state drive to the computer. (The edge of
the module opposite the slot rises away from the computer.)
2. Remove the solid-state drive (2) by pulling the module away from the slot at an angle.
Reverse this procedure to install the solid-state drive.
(Battery Safe mode on page
(Service doors on page 35).
(Service doors on page 35).
Spare part number
L00875-001
L00874-001
L00873-001
34).
Component replacement procedures 45