Advertisement
3.13 Removing the power supply board
(See Fig.14)
• Prior to performing the following procedures, remove the top
cover.
(1) From the top side of the main body, disconnect the parallel
wires from the connector
board 1.
(2) Disconnect the card wire from the connector
power supply board.
(3) Disconnect the relay board from the connector
the power supply board.
(4) Remove the three screws U attaching the power supply
board.
(5) Remove the power supply board from the hook d of the
chassis base bracket in the direction of the arrow, take out
the power supply board.
(6) Turn over the power supply board, remove the solders from
the soldered sections e attaching the wires.
3.14 Removing the headphone jack board
(See Figs.14 and 15)
• Prior to performing the following procedures, remove the top
cover and front panel assembly.
(1) From the top side of the main body, remove the tie bands
attaching the parallel wire. (See Fig.14)
(2) Disconnect the parallel wire from the connector
the main board. (See Fig.14)
(3) From the front side of the main body, remove the nut and
screw V attaching the headphone bracket to the front
bracket. (See Fig.15)
(4) Remove the three screws U attaching the power supply
board. (See Fig.14)
(5) Take out the headphone jack board from the inside of the
chassis base while lifting the power supply board.
3.15 Removing the switch board
(See Fig.16)
• Prior to performing the following procedures, remove the top
cover and front panel assembly.
(1) From the back side of the front panel assembly, remove the
two screws W attaching the switch board.
(2) Take out the switch board, disconnect the wire from the
connector
CN432
on the switch board.
3.16 Removing the power switch board
(See Fig.16)
• Prior to performing the following procedures, remove the top
cover and front panel assembly.
(1) From the back side of the front panel assembly, remove the
two screws X attaching the power switch board.
(2) Take out the power switch board, disconnect the wire from
the connector
CN430
on the power switch board.
CN55
on the power transformer
CN402
on the
CN71
CN881
U
on
CN71
Tie
bands
CN881
Main board
Relay board
on
Nut
Headphone bracket
W
CN432
Switch board
W
Power supply board
CN402
Card wire
Headphone
jack board
Soldered
sections e
CN55
Power
transformer
board 1
Hook d of the chassis base bracket
Fig.14
V
Headphone jack board
Front bracket
Fig.15
Front panel assembly
Power switch board
Fig.16
(No.MB172)1-11
U
U
CN430
X
Advertisement
