Recommendations And Suggestions - AEG DGE5660HM User Manual

1. RECOMMENDATIONS AND SUGGESTIONS

• The Instructions for Use apply to several versions of this ap-
pliance. Accordingly, you may find descriptions of individual
features that do not apply to your specific appliance.
• The manufacturer will not be held liable for any damages result-
ing from incorrect or improper installation.
• The minimum safety distance between the cooker top and the
extractor hood is 650 mm (some models can be installed at a
lower height, please refer to the paragraphs on working dimen-
sions and installation).
• Check that the mains voltage corresponds to that indicated on
the rating plate fixed to the inside of the hood.
• For Class I appliances, check that the domestic power supply
guarantees adequate earthing. Connect the extractor to the
exhaust flue through a pipe of minimum diameter 120 mm.
The route of the flue must be as short as possible.
• Do not connect the extractor hood to exhaust ducts carrying
combustion fumes (boilers, fireplaces, etc.).
• If the extractor is used in conjunction with non-electrical appliances
(e.g. gas burning appliances), a sufficient degree of aeration must
be guaranteed in the room in order to prevent the backflow of
exhaust gas. The kitchen must have an opening communicat-
ing directly with the open air in order to guarantee the entry of
clean air. When the cooker hood is used in conjunction with
appliances supplied with energy other than electric, the negative
pressure in the room must not exceed 0,04 mbar to prevent
fumes being drawn back into the room by the cooker hood.
• The air must not be discharged into a flue that is used for
exhausting fumes from appliances burning gas or other fuels
(not applicable to appliances that only discharge the air back
into the room).
• If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in
order to avoid a hazard.
• If the instructions for installation for the gas hob specify a greater
distance specified above, this has to be taken into account.
Regulations concerning the discharge of air have to be fulfilled.
• Use only screws and small parts in support of the hood.
Warning: Failure to install the screws or fixing device in accord-
ance with these instructions may result in electrical hazards.
• Connect the hood to the mains through a two-pole switch hav-
ENGLISH 3