Download Print this page

Prem-I-Air EH1638 User Manual page 2

Colour changing aroma diffuser and humidifer

Advertisement

These instructions should be read carefully and left with the user of the product for future reference.
Before use please Inspect the product including its cable and plug for any signs of damage. If the product
is damaged, DO NOT use it, and contact your supplier immediately.
OPERATING INSTRUCTIONS
1. Place the humidifier on a flat surface, about 60cm
away from the floor and 10cm away from the wall.
We recommend you do not place the humidifier
directly on to wooden furniture.
2. Remove the outer cover from the unit.
3. Remove the inner cover from the unit.
4. Carefully fill the water tank with cool, fresh water,
being careful not to fill higher than the max level
indicated on the inside of the tank. Do not use hot
or warm water as this may cause the unit to leak.
Do not attempt to fill the unit via the moisture outlet.
5. Add 2-3 drops of essential oil, if desired.
6. Replace the inner cover over the water tank.
7. Replace the outer cover on the unit.
8. Connect the power cord to the power inlet on the
rear of the unit.
9. Connect the mains plug to an electrical outlet.
10. Press the power button to switch the unit on. The
unit will begin to emit mositure/aroma.
11. Pressing the power button a second time will
switch the night light on.
12. Pressing the power button a third time will put the
unit back into standby mode.
OPERATING COSTS
At time of going to press, the average cost of electricity
is £0.13 per unit (kilowatt-hour). The amount you are
being charged will be shown on your electricity bill. At
this cost, the EH1638 will cost 3p per day to run.
PAT TESTING
When used in an office environment, we recommend
that this product should be safety-tested yearly by a
qualified electrician (PAT Tested).
We recommend that it is PAT tested regularly when
used in a domestic environment.
Domestic wiring must be tested periodically by a qualified electrician at least once every 10 years or at
every change of occupancy.
For office and retail premises, and buildings such as village halls, the wiring must be inspected at least
once every 5 years.
It is recommended that all building be fitted with smoke alarms (it is mandatory for new buildings).
IMPORTANT
Installer and Users please note:
GENERAL SAFETY REQUIREMENTS
2
Ver 1 01/2015

Advertisement

loading