Yamaha RX-V483 Quick Start Manual page 13

6
Connecting the power cable to an AC wall outlet,
and turning on the unit
Before connecting the power cable
(Taiwan, Brazil and General models only)
Set the switch position of VOLTAGE
SELECTOR according to your local voltage.
Voltages are AC 110–120/220–240 V,
50/60 Hz.
1
Plug the power cable into an
AC wall outlet.
To an AC wall
outlet
VOLTAGE SELECTOR
110V-
120V
220V-
240V
VOLTAGE SELECTOR
(Taiwan, Brazil and General models only)
2
Press z (receiver power) to
turn on the unit.
ZONEA ZONE A ZONE B ZONE B
SLEEP SLEEP
SCENE SCENE
BD BD
TV TV NET NET
RADIO RADIO
DVD DVD
STRAIGHT STRAIGHT DIRECT DIRECT ENHANCER ENHANCER BASS BASS
PROGRAM PROGRAM
3
Turn on the TV and switch the
TV input to display video from
the unit (HDMI OUT jack).
The Network Setup screen shown below will be
displayed on the TV when the unit is turned on for
the first time after purchase. It may take several
tens of seconds for the screen to be displayed
(WAC: Wireless Accessory Configuration).
z
See "Sharing the iOS device setting" under
"Connecting the unit to a wireless network" in the
Owner's Manual when using this function to
connect the unit to a network.
This document explains wireless connection
using methods other than this function. Follow
the procedure described under "Connecting the
unit to a network" on the next page.
Note
This screen will not be displayed if the unit is connected
to a router via its NETWORK jack (wired connection).
Network Setup WAC
You can share the network's
wireless (Wi-Fi) setting with
this device using a device
with iOS7 or later.
↓ NEXT
To perform network setup using
another method, press ENTER.
CANCEL
RETURN
Language <English>
En
13