Beko WTV 7531 X0 User Manual page 16

5.3 Cleaning the body and control panel
Wipe the body of the machine with soapy water or non-corrosive mild
gel detergents as necessary, and dry with a soft cloth.
Use only a soft and damp cloth to clean the control panel.
5.4 Cleaning the water intake filters
There is a filter at the end of each water intake valve at the rear of the
machine and also at the end of each water intake hose where they
are connected to the tap. These filters prevent foreign substances
and dirt in the water to enter the washing machine. Filters should be
cleaned as they do get dirty.
1 Close the taps.
2 Remove the nuts of the water intake hoses to access the filters on
the water intake valves. Clean them with an appropriate brush. If
the filters are too dirty, take them out by means of pliers and clean
them.
3 Take out the filters on the flat ends of the water intake hoses
together with the gaskets and clean thoroughly under running
water.
4 Replace the gaskets and filters carefully in their places and tighten
the hose nuts by hand.
5.5 Draining remaining water and
cleaning the pump filter
The filter system in your machine prevents solid items such as
buttons, coins and fabric fibers clogging the pump impeller during
discharge of washing water. Thus, the water will be discharged
without any problem and the service life of the pump will extend.
If the machine fails to drain water, the pump filter is clogged. Filter
must be cleaned whenever it is clogged or in every 3 months. Water
must be drained off first to clean the pump filter.
In addition, prior to transporting the machine (e.g., when moving to
another house) and in case of freezing of the water, water may have
to be drained completely.
A
WARNING:
Foreign substances left in the pump filter may
damage your machine or may cause noise problem.
WARNING:
If the product is not in use, turn the tap off,
detach the supply hose and drain the water inside the
machine against any freezing possibility in the region of
installation.
WARNING:
After each use close the supply hose tap of
the product.
In order to clean the dirty filter and discharge the water:
1 Unplug the machine to cut off the supply power.
A
WARNING:
Temperature of the water inside the machine
may rise up to 90 ºC. To avoid burning risk, clean the filter
after the water in the machine cools down.
16 / EN
2 Open the filter cap.
3 Some of our products have emergency draining hose and some
does not have. Follow the steps below to discharge the water.
Discharging the water when the product does not have an
emergency draining hose:
a Place a large container in front of the filter to catch water from the
filter.
b Loosen pump filter (anticlockwise) until water starts to flow. Fill
the flowing water into the container you have placed in front of
the filter. Always keep a piece of cloth handy to absorb any spilled
water.
c When the water inside the machine is finished, take out the filter
completely by turning it.
4 Clean any residues inside the filter as well as fibers, if any, around
the pump impeller region.
5 Install the filter.
6 If the filter cap is composed of two pieces, close the filter cap by
pressing on the tab. If it is one piece, seat the tabs in the lower
part into their places first, and then press the upper part to close.
Washing Machine / User's Manual