Bosch wfd2473 Operating Instructions And Installation page 10

Programme and spin speed
selectors
The programme selector is used to select and
adjust programmes. Turn the selector
clockwise (to the right). Align the setting mark
with the programme required.
See the programme table below.
The temperature selector (according to
model) is used to select the wash temperature.
The maximum programme temperature is set
at 60º C for delicates and 40º C for woollens,
even if a higher temperature has been selected,
so as to avoid damaging delicate items.
Use cold wash or low temperature programs if
the type of laundry and degree of soiling
permits. Washing at 60º C consumes
approximately half as much energy as washing
at 90º C.
If the washing is very soiled and needs to be
washed at 90º C, turn the rotary selector until it
clicks into the 90 position. This will require
some extra effort. It is not a fault but is because
it is regarded as a safety measure.
Washing machine status indicator
lights
The «Wash/Ready» indicator light flashes
when the required programme has been
selected. This indicator light remains lit when
the «Start» button is pressed and the
programme begins.
The «Rinse» indicator light comes on (set)
during the rinse programme.
While the washing machine is spinning and
emptying out the water, the «Spin/End»
indicator light remains lit. The indicator light
flashes when the programme is completed. To
turn the machine off, set the programme
selector to «Off»
10 en
Function and «Start» selection
button
Start
The appliance starts the programme selected
when the button is pressed. The
«Wash/Ready» indicator light comes on.
Preselect the wash programme.
Caution: To prevent damage to the appliance
do not start the machine if the door is not
properly shut, even if the «Wash/Ready»
indicator light is on and the «Start» button is
depressed.
The door of the washing machine cannot be
opened during the washing cycle. The machine
must first be switched off before the door can
be opened (programme selector on «Off»).
Check that the «Spin/End» indicator light has
gone out. The door can be opened after 2
minutes.
Rinse hold
When this button is pressed, the function
indicator light comes on and the laundry
remains in the last rinsing water to avoid
creasing.
x
The function indicator light comes on when this
button is pressed. The spin cycle in the wash
programme for hard-wearing white and
coloured items is carried out at a lower speed.
In the delicates and woollens programme, the
spin cycle is automatically carried out with the
least number of spins, regardless of whether
this button has been pressed