Electrolux WD42A96160 User Manual page 18

18 www.electrolux.com
• Position A for powder detergent (factory setting).
• Position B for liquid detergent.
When you use the liquid detergent:
• Do not use gelatinous or thick liquid detergents.
• Do not put more liquid then the maximum level.
• Do not set the prewash phase.
• Do not set the delay start.
10.5 Activating the appliance
Press the
deactivate the appliance. A tune sounds
when the appliance is activated.
10.6 Setting a programme
1. Turn the programme knob and set
the programme:
• The related programme indicator
comes on.
• The indicator of the
• The display shows the level of the
Time Manager, the programme
duration and the indicators of the
programme phases.
2. If necessary, change the
temperature, the spin speed, the
cycle duration or add available
options. When you activate an
option, the indicator of the set option
comes on.
If you set something
incorrect, the display shows
the message
10.7 Starting a programme
without the delay start
Press
• The indicator of
and stays on.
• The indicator
on the display.
• The programme starts, the door
locks, the display shows the
indicator
button to activate or
.
.
stops to flash
starts to flash
.
flashes.
• The drain pump can operate for a
10.8 Starting a programme with
the delay start
1. Press
display shows the delay you want to
set.
The related indicator comes on the
display.
2. Press
• The appliance starts the
If the indicator
flashes, the door is
locking. If the display
shows an alarm
message after the
indicator has
flashed for a few
seconds, it indicates
that the door is not
properly locked (for
more details see
Troubleshooting
chapter).
short time when the appliance fills
water.
After approximately 15
minutes from the start of the
programme:
• The appliance adjusts
automatically the
programme duration
agree with the laundry
load.
• The display shows the
new value.
again and again until the
:
countdown.