AEG SCS51813F1 User Manual page 12

12 www.aeg.com
Problem
There is too much frost and
ice.
The compressor does not
start immediately after
pressing the FROSTMATIC,
or after changing the tem-
perature.
Water flows on the rear plate
of the refrigerator.
Water flows into the refriger-
ator.
Water flows on the floor.
Temperature cannot be set.
The temperature in the ap-
pliance is too low/too high.
Possible cause
The door is not closed cor-
rectly.
The FROSTMATIC function
is switched on.
The door is not closed cor-
rectly or the gasket is de-
formed/dirty.
The water drainage plug is
not correctly positioned.
Food products are not wrap-
ped properly.
Temperature is set incorrect-
ly.
This is normal, no error has
occurred.
During the automatic de-
frosting process, frost melts
on the rear plate.
The water outlet is clogged.
Food products prevent that
water flows into the water
collector.
The melting water outlet is
not connected to the evapo-
rative tray above the com-
pressor.
The FROSTMATIC or COOL-
MATIC function is switched
on.
The temperature regulator is
not set correctly.
The door is not closed cor-
rectly.
Solution
Refer to "Closing the door".
Refer to "FROSTMATIC
function".
Refer to "Closing the door".
Position the water drainage
plug in the correct way.
Wrap the food products bet-
ter.
Refer to "Operation" chap-
ter.
The compressor starts after a
period of time.
This is correct.
Clean the water outlet.
Make sure that food prod-
ucts do not touch the rear
plate.
Attach the melting water
outlet to the evaporative
tray.
Switch off FROSTMATIC or
COOLMATIC manually, or
wait until the function resets
automatically to set the tem-
perature. Refer to "FROST-
MATIC or COOLMATIC
function".
Set a higher/lower tempera-
ture.
Refer to "Closing the door".