Replacing The Grass Deflector - Toro 30255 Operator's Manual

2
3
5
Figure 62
1. Locknut
2. Wheel Bolt
3. Bushing
5. To assemble, place one (1) bushing into the wheel hub.
Grease the roller bearing and spanner bushing and
slide them into the wheel hub. Place the second
bushing into the wheel hub (Fig. 62).
6. Install the castor wheel into the castor fork and secure
with the wheel bolt and locknut. Tighten the locknut
until the spanner bushing bottoms against the inside of
the castor forks (Fig. 62).
7. Grease the fitting on the castor wheel.

Replacing the Grass Deflector

Warning
An uncovered discharge opening could allow the
lawn mower to throw objects in the operator's or
bystander's direction and result in serious injury.
Also, contact with the blade could occur.
Never operate the lawn mower unless you install a
cover plate, a mulch plate, or a grass chute and
catcher.
1. Remove the locknut, bolt, spring and spacer holding
the deflector to the pivot brackets (Fig. 63). Remove
damaged or worn grass deflector.
2. Place spacer and spring onto grass deflector. Place the
"L" end of spring behind deck edge.
Note: Make sure the "L" end of spring is installed behind
deck edge before installing the bolt as shown in figure 63.
1
4
3
4. Spanner Bushing
5. Roller Bearing
3. Install bolt and nut. Place "J" hook end of spring
around grass deflector (Fig. 63).
Important
The grass deflector must be able to lower
down into position. Lift the deflector up to test that it
lowers into the full down position.
8
6
1
Figure 63
1. Bolt
2. Spacer
3. Locknut
4. Spring
5. Spring installed
39
4
2
3
5
7
6. Grass Deflector
7. "L" end of spring, place
behind deck edge before
installing bolt
8. "J" hook end of spring