Toro 39696 Operator's Manual page 22

Figure 19
1. Control rod
2. Control rod fitting
3. Idler bracket
2. Loosen the upper flange bolts (3/8 x 1 inch) and
flange nut securing handle to rear frame (Figure 20).
Figure 20
1. Upper handle
2. Rear frame
3. Flange bolt (3/8 x 1 inch)
3. Remove the lower flange bolts (3/8 x 1 inch)
and flange nuts securing handle to rear frame
(Figure 20).
4. Pivot handle to desired operating position and
install lower flange bolts (3/8 x 1 inch)and flange
nuts into mounting holes. Tighten all flange bolts.
5. Thread rod fitting up or down on rod until proper
position is attained and install into fitting to idler
bracket with clevis pin, washer and hairpin cotter.
6. Check the parking brake adjustment. Refer to
Checking the Brakes in Brake Maintenance ,
page 32.
4. Clevis pin
5. Washer
6. Hairpin cotter pin
4. Lock nut (3/8 inch)
5. Upper mounting hole
6. Lower mounting hole
22