Servicing The Spark Plug - Toro 30197 Operator's Manual

1
3
Figure 35
1. Oil filter
2. Gasket
4. Install the replacement oil filter to the filter adapter.
Turn the oil filter clockwise until the rubber gasket
contacts the filter adapter, then tighten the filter an
additional 1/2 turn (Fig. 35).
5. Fill the crankcase with the proper type of new oil; refer
to Changing/Draining Oil, page 27.

Servicing the Spark Plug

Service Interval/Specification
Check the spark plug(s) after every 200 operating hours.
Make sure the air gap between the center and side
electrodes is correct before installing the spark plug. Use a
spark plug wrench for removing and installing the spark
plug(s) and a gapping tool/feeler gauge to check and adjust
the air gap. Install a new spark plug(s) if necessary.
Type: Championr RC12YC or Championr Premium Gold
2071 (or equivalent)
Air Gap: 0.040 in. (1.00 mm)
Removing the Spark Plug
1. Disengage the power take off (PTO), set the parking
brake, and turn the engine off.
2. Pull the wire(s) off the spark plug(s) (Fig. 36). Now
clean around the spark plug(s) to prevent dirt from
falling into the engine and potentially causing damage.
3. Remove the spark plug(s) and metal washer.
2
m–1256
3. Adapter
(s)
28
2
Figure 36
1. Spark plug wire
Checking the Spark Plug
1. Look at the center of the spark plug(s) (Fig. 37). If you
see light brown or gray on the insulator, the engine is
operating properly. A black coating on the insulator
usually means the air cleaner is dirty.
Important
Never clean the spark plug(s). Always
replace the spark plug(s) when it has: a black coating, worn
electrodes, an oily film, or cracks.
2. Check the gap between the center and side electrodes
(Fig. 37). Bend the side electrode (Fig. 37) if the gap is
not correct.
2
1
Figure 37
1. Center electrode insulator
2. Side electrode
Installing the Spark Plug
1. Install the spark plug(s) and metal washer. Make sure
the air gap is set correctly.
1
m–4757
2. Spark plug
3
0.040 in.
(1.00 mm)
3. Air gap (not to scale)
(s)