Wiring Diagram; Cleaning And Storage - Toro 30178 Operator's Manual

Wiring Diagram

J4
J5
WIRE LIST
DESIG. AWG COLOR ROUTE
W1 16 WHITE J2 J4
W2 16 WHITE J2 J3
W3 16 BLUE P1–1 J5
W4 16 BLACK P1–2 J1

Cleaning and Storage

1. Disengage the power take off (PTO) and set the parking
brake.
2. Remove grass clippings, dirt, and grime from the
external parts of the entire machine, especially the
engine. Clean dirt and chaff from the outside of the
engine's cylinder head fins and blower housing.
Important
You can wash the machine with mild
detergent and water. Do not pressure wash the machine.
Avoid excessive use of water, especially near the control
panel, and engine.
3. Check the brake; refer to Servicing the Brakes, page 30.
4. Service the air cleaner; refer to Servicing the Air
Cleaner, page 25.
5. Grease the machine; refer to Greasing and Lubrication,
page 29.
6. Change the crankcase oil; refer to Servicing the Engine
Oil, page 26.
7. Check the tire pressure; refer to Checking the Tire
Pressure, page 29.
8. For long-term storage (more than 90 days) add
stabilizer/conditioner additive to fuel in the tank.
W1
W3
1 2
P1 PTO
Note: Do not store stabilizer/conditioned gasoline over 90
days.
9. Remove the spark plug(s) and check its condition; refer
10. Check and tighten all bolts, nuts, and screws. Repair or
11. Paint all scratched or bare metal surfaces. Paint is
12. Store the machine in a clean, dry garage or storage area.
35
J3
KILL
W2
W4
A. Run engine to distribute conditioned fuel through
the fuel system (5 minutes).
B. Stop engine, allow to cool and drain the fuel tank;
refer to Servicing the Fuel Tank, page 31, or operate
engine until it stops.
C. Restart engine and run until it stops. Repeat, on
choke until engine will not restart.
D. Dispose of fuel properly. Recycle as per local codes.
to Servicing the Spark Plug, page 28. With the spark
plug(s) removed from the engine, pour two tablespoons
of engine oil into the spark plug hole. Now use the
starter to crank the engine and distribute the oil inside
the cylinder. Install the spark plug(s). Do not install the
wire on the spark plug(s).
replace any part that is damaged or defective.
available from your Authorized Service Dealer.
Cover the machine to protect it and keep it clean.
J2
MAG
J1
GND