Advertisement
Available languages
Available languages
Transmitter
Switch Charge/Off/On
Up / down
Charge indicator LED
INSTALLATION AND BATTERY CHARGE
Transmitter:
Switch in position OFF
1. Open the battery cover.
2. Fit the batteries (respect polarity).
3. Close battery cover.
Helicopter:
Switch in position OFF.
1. Open the charger cable cover.
2. Connect the cable to the helicopter.
3. Switch ON the transmitter.
4. Green LED will turn on. When the process finishes the LED will turn off. (Charging time approx. 20-30 min).
5. Disconnect the plug. The flying time is 6-8 min.
6. It is also possible to charge the helicopter directly from a computer or USB charger with the USB cable.
HELICOPTER FLIGHT
1. Select the band in the transmitter A, B o C and the helicopter will automatically identify it.
2. With the helicopter switched off, first switch on the transmitter.
3. Switch on the helicopter.
4. Place the helicopter in the floor.
5. Synchronizing transmitter and helicopter: Full push the left stick for a second.
Trim adjustments:
1. Push again the left stick SLOWLY to start the flight (approx. between 0,5m and 1m).
2. If the tail turns left or right, please trim it using the trim button on the transmitter. Press it left or right until the helicopter stops turning.
Flight control:
Up
Down
Push left stick
Pull left stick
NINCOAIR is brand of NINCO DESARROLLOS S.L.
Ctra. de l'Hospitalet 32
08940 Cornella Barcelona Spain
CIF B-60307725 ·
www.nincoair.com
- 6 -
On / Off indicator LED
Turn right / left
Tri-band channel
Trim
Cover and charge wire
Advertisement
