How To Install The Monitor; Mounting Precautions - Sharp PN-425 Operation Manual

How to Install the Monitor

Mounting precautions

• Since the monitor is heavy, consult your dealer before
installing, removing or moving the monitor.
• When installing, removing or moving the monitor, ensure
that this is carried out by at least 2 people.
• When moving the monitor, be sure to hold it with the
handles both on the rear and the unit bottom. Do not hold
the LCD panel. This may cause product damage, failure, or
injury.
• Install the monitor with the surface perpendicular to a level
surface. If necessary, the monitor may be tilted up to 20
degrees.
• Mounting the monitor on the wall requires special expertise
and the work must be performed by an authorized SHARP
dealer. You should never attempt to perform any of this
work yourself. Our company will bear no responsibility
for accidents or injuries caused by improper mounting or
mishandling.
• This monitor should be used at an ambient temperature
between 32°F (0°C) and 104°F (40°C). Provide enough
space around the monitor to prevent heat from accumulating
inside.
For the monitor in horizontal orientation
7-7/8 [20]
2
[5]
2 [5]
For the monitor in vertical orientation
7-7/8 [20]
2 2
[5] [5]
2 [5]
Unit: inch [cm]
2-3/4 [7]
2
[5]
Unit: inch [cm]
2-3/4 [7]
• If it is difficult to provide this much space for any reason
such as the installation of the monitor inside a housing, or
if the ambient temperature may be outside of the range
of 32°F (0°C) to 104°F (40°C), install a fan in the housing
or take other measures to keep the ambient temperature
within the required range.
• Adhere to the following when installing the monitor in the
vertical orientation. Failing to adhere to the following may
cause malfunctions.
- Install the monitor such that the power LED is located on
the downside.
- Set MONITOR on the MODE SELECT 2 menu to
PORTRAIT. (See Operation guide.)
• Do not block any ventilation openings. If the temperature
inside the monitor rises, this could lead to a malfunction.
• After mounting, it is recommended to take some measures
to prevent the monitor from falling down.
• Do not place the monitor on a device which generates heat.
• Use the supplied vertical logo sticker when you install the
monitor in vertical orientation.
*
* Do not remove the factory-affixed sticker but affix the
logo sticker over it. Be careful not to cover the remote
control sensor or buttons.
• Be sure to use a stand or a wall-mount/ceiling-mount
bracket designed or designated for mounting the monitor.
• This monitor is designed to be installed on a concrete wall,
ceiling, or pillar. Reinforced work might be necessary for
some materials such as plaster / thin plastic board / wood
before starting installation.
This monitor and bracket must be installed on a wall which
can endure at least 4 times or more the weight of the
monitor. Install by the most suitable method for the material
and the structure.
• For use only with UL Listed Wall Mount Bracket with
minimum weight/load: 88 kg.
9
E