Steering Control Levers; Park Brake; Ignition Switch - Husqvarna Z 246i Operator's Manual

CONTROLS

Steering Control Levers

The machine's speed and direction are
continuously variable using the two steering
controls. The steering controls can be moved
forward or backward about a neutral position.
There is a neutral position, which is locked if the
steering controls are moved out.
When both controls are in the neutral position (N),
the machine stands still.
By equally moving both controls forward or
backward, the machine moves in a straight line
forward or backward.
For example, to turn right while moving forward,
move the right control towards the neutral
position. The rotation of the right wheel is reduced
and the machine turns to the right.
Zero turn can be achieved by moving one control
backward (behind the neutral position) and
carefully moving the other steering control forward
from its neutral position. The rotation direction
when zero turning is determined by which
steering control is moved backward behind the
neutral position. If the left steering control is pulled
backward, the machine turns to the left. Use more
care when using this maneuver.
If the steering controls are in uneven positions
when standing still or do not fit in the slots for
moving the controls out, they can be adjusted.
Forward
Park
Neutral
Brake
Reverse
WARNING! The machine can turn very
rapidly if one steering control is moved much
further forward than the other.

Park Brake

The park brake is integrated with the steering
control levers. Move both levers out from the
neutral position to engage the park brake.
To release the park brake, pull both steering
control levers inwards to the neutral position at
the same time. Do not try to operate the unit
without both levers being inwards out of the
engaged position or machine components could
be damaged.
IMPORTANT INFORMATION
the steering / park brake controls inward at the
same time will cause the unit's safety system to
shut the unit down.

Ignition Switch

The ignition switch is placed on the control panel
and is used to start and stop the engine.
Failure to bring
13