Return To Cembre For Overhaul - Cembre B1350-C Operation And Maintenance Manual

4.4)
ERRORS: these appear during operation, combined with a beep and fl ashing
LED Worklights, to notify the operator of procedural or operational errors.
Message Error description
The pressure release button (5)
was pressed before the control
ERROR
parameters were reached (Force/
Pressure).
Abnormal power consumption
of the motor for more than 3
001
seconds.
The tool stops.
Output voltage of the pressure
002
transmitter is out of the pre-set
range.
Failure to reach the set pressure
003
within 30 seconds of continuous
operation of the machine.
Overcharging of the battery with
protection tripping.
004
The tool stops.
Error screens are displayed for about 30 seconds before being reset, but will
display repeatedly in the event of permanent anomalies.

5. RETURN TO Cembre FOR OVERHAUL

In the case of a breakdown, contact your local Agent who will advise you on the
problem and give you the necessary instructions on how to dispatch the tool
to our nearest service Centre; if possible, attach a copy of the Cembre Test
Certifi cate supplied with the tool or, if no other references are available, indicate
the approximate purchase date and the tool serial number.
Solution
Repeat the work cycle and wait for the
motor to stop automatically.
Wait for the display to turn off (60 sec.)
or remove and re-insert the battery,
then re-start the tool.
If the error occurs frequently, contact
Cembre.
Repeat the work cycle; if the error
occurs frequently, contact Cembre.
Repeat the work cycle; if the error
occurs frequently, contact Cembre.
Wait for the display to turn off (60 sec.)
or remove and re-insert the battery,
then re-start the tool.
If the error occurs frequently, contact
Cembre.
12