Table of Contents
Advertisement
R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -1. Armature, Spiral bevel gear 7 (cont.)
DISASSEMBLING
(2) Disassemble the commutator end of Armature as drawn in Fig. 3.
Fig. 3
1. Pick up three tabs of
Self lock 6 with tweezers
to remove it from Armature.
3. Remove Ball bearing 627DDW with 1R269.
1R269
Ball bearing 627DDW
ASSEMBLING
(1) Assemble Spiral bevel gear 7 to Armature end by reversing the disassembly procedure. (Refer to Fig. 2)
(2) Assemble the commutator end of Armature as drawn in Fig. 4.
Fig. 4
1. Return tabs of Self lock 6 to their
normal shape before assembling.
Then, mount Wave washer 6 to
the commutator end of Armature.
Note: Be sure to mount the washer
as following direction.
Self lock 6
Magnet sleeve
Wave washer 6
2. Remove Magnet sleeve,
Tabs
Self lock 6
Tweezers
4. Remove Flat washer 7 and
2. Press down Self lock 6 until
Wave washer 6 gets flat.
Wave washer 6 and
Labyrinth rubber ring 22.
Magnet sleeve
Wave washer 6
Labyrinth rubber ring 22
Insulation washer.
Flat washer 7
Insulation washer
3. Magnet sleeve is stabilized
between Self lock 6 and
Wave washer 6 by the reaction
force of Wave washer 6.
P 4/ 12
Self lock 6
Magnet sleeve
Wave washer 6
Advertisement
Table of Contents
