Water Tank; Ultrasonic Disk - pureguardian H900 Use & Care Instructions Manual

Make sure the unit is unplugged.
1. Separate the tank from the body of the unit.
2. Open the tank lid, turning it to
the left.
4. Close the tank lid, turning it
to the right. Then, re-attached the
tank to the body of the unit.
6. Press the button to turn on.
*See Mode Chart for further
operating instructions.
E-6
3. Pour cool, clean water directly into
the tank. Do not pour anything but
water into the tank.
5. Plug power adapter into back of
humidifier unit. Plug into outlet.
NOTE: If you live in a hardwater
area, we recommend the use of
distilled water for your humidifier.
This will help reduce the precipi-
tation of minerals or 'white dust.'
• Always unplug the unit before servicing it in any way.
• Do not submerse the unit in water, or allow water to enter the inside of the unit.
INSIDE THE BODY OF THE UNIT
Pour excess water out of the unit. Wash out the unit with fresh water, using the cleaning
brush and a soft cloth as needed.
OUTER SURFACE OF THE UNIT
Wipe the surface of the unit with a soft damp cloth if needed.

WATER TANk

Fill water tank with clean water and shake to remove water scaling.

ULTRASONIC DISk

Remove the water tank and use the enclosed cleaning brush and 1 teaspoon of water
and vinegar solution, every 1 to 2 weeks to remove build-up and deposits from this area.
Do not use any detergents or soap as this may damage the ultrasonic disc. This may
also disperse detergent or soap residue that could be harmful to your health.
Do not scrub with finger tips or any sharp objects as this may cause damage
to the ultrasonic disc.
*Clean the disk with the brush only. No other cleaning tool should be used. Brush only.
• Fully dry the inside and outside of the unit before storing it.
• DO NOT leave water in the unit.
• Store in a cool, dry place.
E-7