Advertisement
Quick Links
Optional Output Connectors for CE Series Amplifiers
Installation Guide (CEAS1/CEAS2)
TOOLS REQUIRED:
Torx #T-15 screwdriver
INCLUDES:
2 - #8 x 1¼ in. screws
• CE optional output connector
WARNING: CEAS1 AND CEAS2 OPTIONAL OUTPUT
CONNECTORS MUST BE INSTALLED BY A QUALIFIED
SERVICE CENTER.
Follow the installation instructions provided on the next
page to install your CE Optional Output Connector. Once
installed, your CE amplifier will offer barrier block or 5-way
binding post output connectors (depending on the kit
ordered).
Note that installing the optional output connectors does
NOT defeat the Neutrik
®
Speakon connectors on the back
panel of the amplifier. If, at any time, you prefer to use the
®
standard Neutrik
Speakon
®
necessary to remove the optional output connector panel
from the amplifier. Instead, simply connect your speaker
wires to the Speakon
®
output connectors instead of the
optional output connectors.
page 1 of 2
CE Series Amplifier with Optional Output Connector Installed
output connectors, it is not
P.O. Box 1000 Elkhart, IN 46515 Phone: (219) 294-8000 Fax: (219) 294-8250
Web Page: http://www.crownaudio.com
OUTPUT CONNECTOR
PART # CEAS1
CE Series Amplifier Barrier Strip
Output Connectors
PART # CEAS2
CE Series Amplifier 5-Way Binding Post
Output Connectors
128271-1
10/99
Advertisement
Summary of Contents for Crown CEAS1
- Page 1 Torx #T-15 screwdriver INCLUDES: 2 - #8 x 1¼ in. screws • CE optional output connector WARNING: CEAS1 AND CEAS2 OPTIONAL OUTPUT CONNECTORS MUST BE INSTALLED BY A QUALIFIED SERVICE CENTER. Follow the installation instructions provided on the next page to install your CE Optional Output Connector. Once...
- Page 2 5. Remove the two T-15 torx-head screws from the rectangular cover plate on the back panel, and retain screws. Remove cover plate and discard. 6. Install CEAS1/CEAS2 in back panel opening and affix with cover-plate screws. 7. Attach wires to main PWA as follows (refer to the illustration above): Red wire to relay K100 “ON”...