Preparation; What To Do For Energy Saving; First Use - Beko NEOFROST User Manual

4

Preparation

4 1

What to do for energy saving

Connecting the product to
A
electronic energy-saving
systems is harmful, as it may
damage the product.
•
Do not keep the refrigerator doors
open for long periods.
•
Do not place hot food or beverages
into the refrigerator.
•
Do not overfill the refrigerator;
blocking the internal air flow will
reduce cooling capacity.
•
In order to store the maximum
amount of food into the cooler
compartment of your refrigerator,
you should take out the upper
drawers and place it onto the
glass rack. The declared energy
consumption of your refrigerator was
determined by taking out the cooler,
ice tray and upper drawers in a way
that will enable maximum storage.
Using the below drawer when storing
is strongly recommended. Energy
saving function should be activated
for best energy consumption.
•
You should not block the airflow by
putting food in front of the cooler
fan. A space of minimum 3cm must
be left in front of the protective fan
wire when placing food.
•
Depending on the product's features;
defrosting frozen foods in the cooler
compartment will ensure energy
saving and preserve food quality.
•
Food should be stored using the
drawers in the cooler compartment
in order to ensure energy saving and
protect food in better conditions.
•
Food packages should not be in
direct contact with the heat sensor
located in the cooler compartment.
If they are in contact with the sensor,
energy consumption of the appliance
Refrigerator / User Guide
might increase.
•
Make sure the foods are not in
contact with the cooler compartment
temperature sensor described below.
4 2

First Use

Before using your refrigerator, make
sure the necessary preparations are
made in line with the instructions in
"Safety and environment instructions"
and "Installation" sections.
•
Keep the product running with no
food inside for 6 hours and do not
open the door, unless absolutely
necessary.
C
A sound will be heard when
the compressor is engaged. It is
normal to hear sound even when
the compressor is inactive, due to
the compressed liquids and gasses
in the cooling system.
C
Front edges of the product might
heat up. This is normal. These areas
are designed to warm up in order
to prevent condensation.
C
In some models indicator panel
turns off automatically 5 minutes
after the door closes. It will be
reactivated when the door is open
or any button is pressed.
9/23 EN