iCartech AURORA G7 User Manual page 69

(4) Insert the unit into the bracket, fasten the M4x6 screw to the fireproofing board available at the
back of the dashboard, and use 4 pieces of M2x2 screw to lock the assemble bars and the
mounting bracket in position.
Note:
According to the depth of the opening, use different length of assemble bar accordingly. If the
opening is too shallow, the monitor may be extended out 10mm from the dashboard.
Method B
(1) Insert this unit directly to the opening of the dashboard.
(2) Place M4x3, M5x5 cylindrical screw or M5x5 cone shaped screw through the holes of the mounting
frame located inside the opening to holes of the unit and fasten the screws to left & right.
Trim Ring installation
Attach the trim ring around the front panel with two indentions on one side facing upwards
Uninstall
Disassemble trim ring
(1) Push the trim ring upward and pull out the upper part.
Installation and uninstall
EN-31