How To Remove Parts - Hitachi R-SF57BMS How To Use Manual

HOW TO REMOVE PARTS

Notice ● Make sure no stored items remain before removing a part.
● Do not remove parts which are not described below.
4 level adjustment shelf
● Slightly lift the shelf up and slide it forward.
Push in the shelf as far as it will go to place.
Caution
Make sure the shelf has been placed in a horizontal position.
Check the shelf to see that it does not come off when sliding it forward.
● Draw the shelf, and pull
off the two pins on the
lower right and remove it.
● Lift up the door pocket while tapping the left/right of its
bottom surface, and remove it.
Insert the door pocket fully to the end when installing it.
Height adjustable upper and lower shelf
Slightly lift up the back
1
of the shelf and draw it.
When installing the shelf, slide it until it reaches to the interior wall, then slightly lift up
the back of the shelf and push it in. (hitch the forks of the shelf to the parts on the back
of the shelf)
Caution
Door may damage if drawing the shelf without turning it.
Lower Freezer (Slimline slide case, slide case and lower freezer case)
Draw the door fully, and draw the Slimline slide case and the Slide case respectively.
1
Slimline slide case
Slide case
Vegetable Compartment (Spacious Upper Case, Lower Case)
Spacious Upper Case
1
● Draw the door fully and
pull up the Spacious
vegetable case as
shown in the fi gure.
48
Fixed shelf
Raise the shelf as shown in fi gure,
2
and turn it and remove it.
Forks of the shelf
Pin (right and left)
Fork (right and left)
Rectangle hole
in the frame
2
● Lift up the front part
of the door, and
draw it further and
incline it.
Vacuum Case with the door
● Pull the door, lift the case
at the edge of it lightly, and
then pull it out. For more
information.
● Slightly lift up and pull out.
Form (Two
locations)
Door pocket
When installing it, insert the pins
on the left/right of the Lower
freezer case into the square holes
on the frame to install it.
Moreover, hitch the pins on the
left/right of the Slide case to the
outside of the Lower freezer case.
Lower Case
3
● Lift up the Vegetable Case.
● When installing it, insert
the pins on the left/
right inner sides of the
Vegetable Case into the
square holes on the frame,
and put the edge of the
Vegetable Case on the
frame to install it.
Pg.39
Reversible shelf
Tap
Tap
Ice Compartment/ Upper Freezer
● Draw the door fully and lift
up the case towards you.
Put the case bottom on the
frame and set the case.
Lift up the Lower freezer
2
case.
Lower freezer case
Frame
■ How to install the slide door
Ice Compartment/Upper Freezer
Vegetable Compartment/Lower Freezer
Tap
Tap
Frame
Frame