Panasonic KX-tg2248CS Operating Instructions Manual page 58

✿✤✦✪✤✧Z✮_✩.❇m 5✫
Troubleshooting
Problem
You cannot operate the
Answering System with the
base unit.
You cannot operate the
Answering System from a
touch tone phone.
You cannot operate the
Answering System with the
handset.
While recording a greeting
message, the unit starts to
ring and stops recording.
During playback, the unit
starts to ring and stops
playback.
Call information is not
displayed during message
playback (p. 47).
General
Problem
The unit does not work.
58
] ]
Cause & Remedy
• The handset user is operating the Answering
System, or is on the phone. Wait until the
IN USE/CHARGE indicator light goes out.
• Make sure you enter the correct remote code
(p. 50).
• The Answering System may not respond if the
tones are too short to activate the unit. Press
each button firmly.
• The Answering System is off. Turn it on
(p. 52).
• Someone is operating the Answering System.
• You are too far from the base unit. Walk closer
to the base unit.
• The unit is recording a message. To answer
the call, press [ ] or [
• To answer the call, press [
again from the beginning after hanging up.
• To answer the call, press [
resume playback, press [MESSAGE/SLOW
TALK] after hanging up.
• Call information will not be displayed
— if a message is recorded by using
[MEMO/2WAY REC] (p. 49), or
— if the Caller List is renewed and the Caller
List item is erased (p. 29).
Cause & Remedy
• Check the settings (p. 8–10).
• Check whether the dialing mode setting is
correct (p. 14).
• Charge the battery fully (p. 9).
• Clean the charge contacts and charge again
(p. 10).
• Install the battery properly (p. 8).
• Place the handset on the base unit and
unplug the AC adaptor to reset it. Plug in, and
try again.
• Re-install the battery (p. 8) and charge it fully.
_
] .
] or [ ] . Try
] or [ ] . To