Page 2
3. Install the brewer in proper location as instructed in this manual. 4. Do not use accessory parts not recommended by Touch Coffee & Beverages, LLC. Using unauthorized accessory parts may result in fire, electrical shock or injury to persons.
Page 3
SAVE THESE INSTRUCTIONS Warning to user and parents 1. Brewer injects EXTREMELY HOT WATER! DO NOT let children use the brewer without adult supervision. 2. After brewing cocoa or soluble, IMMEDIATELY RUN an 8 oz. brew cycle without the Pod in the brewer to rinse the brewer. This will avoid clogging up the two Needles in the Red Cup Holder.
TABLE OF CONTENTS Using Touch’s T714C Brewing System PART 1. SET-UP Helpful Hints ................................Unpacking Instructions ............................. Product Features ..............................PART 2. BREWING A CUP Setting Up Your Brewer ............................Ready to Brew Your First Cup ..........................Stopping the Brew Process ............................
12 -14 oz cup of coffee. 4. T714C model offers five cup sizes (6 oz, 8 oz, 10 oz, 12 oz, 14 oz) and three taste preference buttons to suit your taste: MILD for mild strength coffee;...
PART 1. SET-UP Product Features T714C Brewer parts Controls and Indicators Cover Power Button Cover Handle Low Water Indicator Red Cup Holder Brewing Indicating Light Deep Well 6 oz Button Housing 8 oz Button Power Cord 10 oz Button Drip Tray Slots...
PART 2. BREWING A CUP Setting Up Your Brewer IMPORTANT: DO NOT use the brewer until it has been set-up for its first use. NOTE: If the brewer has been exposed to temperatures below freezing, allow the brewer at least two hours to reach room temperature before using it. A frozen or extremely cold brewer may not operate properly.
Page 8
PART 2. BREWING A CUP Setting Up Your Brewer (Continued) CAUTION: DO NOT pull the Latch to open the Cover during the brewing period. (Fig. 4) CAUTION: Extremely Hot Water! (Fig. 5) 6. With the cover closed, press the 10 oz Button to start the brewing cycle. (Fig. 5) The brewing indicating light on the upper right corner will stay ON while the brewer is warming up.
PART 2. BREWING A CUP Ready to Brew Your First Cup 1. Make sure the brewer is powered ON. Place a cup or mug on the Drip Tray. 2. Pull on the Latch to open the Cover. (Fig. 7) Insert a desired Pod into the Red Cup Holder. (Fig. 8) NOTE: DO NOT remove the foil lid or puncture the Pod.
Page 10
PART 2. BREWING A CUP Ready to Brew Your First Cup (Continued) 5. The upper right brewing indicating light will stay ON during warm up, and the light will BLINK during the brewing cycle. (Fig. 10) CAUTION: The brewer will heat the water EXTREMLY HOT during the brewing process. To avoid risk of injury, do not pull on the Latch or open the Cover while brewing.
PART 2. BREWING A CUP Stopping the Brew Process If you need to stop the brewing process for any reason, then press on the Power Button to turn OFF the brewer. NOTE: If the brewer is turned ON after terminating the previous brewing process, the next brewing cycle may NOT brew a full cup. We recommend performing a brewing cycle without the POD, and then restart the brewing cycle with a POD in the Red Cup Holder.
PART 3. MAINTENANCE Cleaning External Parts We recommend regularly cleaning the brewer’s external components. CAUTION: Only use a moist cloth and if necessary a mild detergent (never use abrasive or aggressive detergents). Do not wash machine parts in the dishwasher. (Fig. 13) 1.
PART 3. MAINTENANCE Cleaning the top Needle (Continued) CAUTION: Top Needle is very sharp. To avoid risk of injury, do not directly touch this Needle with your finger. (Fig. 15) Cleaning the Red Cup Holder 1. Open the Cover, and remove the Red Cup Holder from the brewer by pulling on it. (Fig.16) 2.
PART 4. TROUBLESHOOTING Brewer does not have power. • Plug the brewer into an independent outlet. • Check to be sure that it is plugged in securely. • Plug into a different outlet. • Reset your home’s circuit breaker, if necessary. •...
Page 15
PART 4. TROUBLESHOOTING The Brewed Water is not Hot Enough. • The water temperature can depend on the water temperature inside the Water Tank. If you recently filled the Water Tank with cold water, then brewed water may not seem hot as usual. Pour some warm water into the Water Tank so that water temperature is about 24°C or 75°F. •...
It is recommended that you fill out and return the warranty card enclosed with the brewer so that the purchase information will be stored in our system. Touch will, at its option, repair or replace a defective brewer without charge upon its receipt of proof of the date of purchase. If a replacement brewer is necessary to service this warranty, the replacement brewer may be new or reconditioned.
Page 17
Touch Customer Service to obtain a Return Merchandise Authorization (RMA) number. Touch brewers returned without an RMA number will be returned to the sender without servicing. Touch is committed to your satisfaction. If you have questions, just give us a call to have them answered quickly without leaving the comfort of your home. Touch Coffee & Beverages, LLC 15312 E.
Page 18
I would like to receive product news and information and special offer as described in your Privacy Policy at www. touchbeverages.com / privacy-policy. First Name Mail the Warranty and Registration Card to: Last Name Touch Coffee & Beverages, LLC 15312 E. Valley Blvd. City of Industry, CA. 91746 U.S.A...
Need help?
Do you have a question about the T714C and is the answer not in the manual?
Questions and answers