Medic Rinse; Tub Clean; Add Load - LG WD12590D6 Owner's Manual

H ow to use washer

Medic Rinse

For best results or for
cleaner rinsing.
This allows the final rinse
to be heated to 40 degrees.
1. Press the Power button.
2. Select a cycle.
3. Press the Medic Rinse button.
4. Press the Start/Pause button.

Tub Clean

TUB CLEAN is special
cycle to clean the inside of
the washer. This cycle uses
higher water level with higher spin speed.
Perform this cycle regularly.
How to use the Tub Clean cycle:
1. Remove any clothing or items from the
washer and close the door.
2. Open the dispenser drawer and add Anti
limescale (Calgon) to the Main wash
compartment.
NOTE: Do not add any detergent to the
detergent compartments. Excessive
suds may generate and leak from the
washer.
3. Close the dispenser drawer slowly.
4. Power On and then press Tub Clean (
button.
5. Press the Start/Pause button to start.
6. After the cycle is complete, leave the door
open to dry around the washer door opening,
flexible gasket and door glass.
CAUTION: If there is a small child, be
!
careful not to leave the door
open for too long.
22

Add Load

• How to use "Add Load"
- Press the "Add Load" button.
- Close the door after add loads or remove
the foreign material(e.g. coin or pin etc.)
- Press the "Start/Pause" button.
• Open the door when "Door Lock" is off after
checking the safety.
• Results when choosing "Add Load" during
cycles
- When the tub is spinning: Tub stops and
"Door Lock" is off.
- When water temperature in the tub is higher
than 45°C: "Add Load" is not available with
short warning sound for safety.
- When lots of water is in the tub: "Door Lock"
is off after draining by safe water level.
• "Add Load" doesn't work when "Tub
Cleaning" course is in progress for safety
NOTE
Put the laundry into the tub completely.
)
Laundry caught in between door closing part
can damage door packing (rubber part) and
might cause failure.
Use this function to add
loads or remove the foreign
material.