UniKit UX300-FCC User Manual

Usb fm transmitter

UniKit

UX300-FCC

www.unikit.com

USB FM TRANSMITTER

USA

This device complies with Part 15 of the FCC rules. Operation of this device is subject to

the following two conditions: (1) this device may not cause harmful interference; and (2)

this device must accept any interference received, including interference that may

cause undesired operation.

WARNING

This device operates on the commercial FM band and signals transmitted can be

received on any standard FM receiver. Users should take great care when operating

this device in order to not cause any interference with reception of any commercial

transmission.

In the USA, the use of this device is governed by Part 15 of the FCC rules.

Details on these regulations and standards can be found on the internet at:

http://www.fcc.gov

Any modification of this device will void the user's authority to operate this device under

these regulations and standards. UniKit Electronics Corporation, its shareholders,

directors, employees, parent companies, distributors or resellers are not responsible for

any financial loss or violation of local laws by the user when operating this device. Users

are urged to check their local communication and broadcasting laws.

Manufactured by:

UniKit Electronics Corporation

#121 – 3823 Henning Drive

Burnaby • BC • V5C 6P3 • Canada

www.unikit.com

Table of Contents

Need help?

Do you have a question about the UX300-FCC and is the answer not in the manual?

Page 1 Any modification of this device will void the user’s authority to operate this device under these regulations and standards. UniKit Electronics Corporation, its shareholders, directors, employees, parent companies, distributors or resellers are not responsible for any financial loss or violation of local laws by the user when operating this device. Users are urged to check their local communication and broadcasting laws.
Page 2 NTRODUCTION The UX300 FM Transmitter is a USB device intended to transmit audio from your desktop computer or notebook to nearby FM radios all over your home or office without cables or wires. The Ux300 is a truly plug-and-play device and is simply connected to your computer via the supplied USB cable.
Page 3 Once the transmitter has been fully recognized by the operating system the “On Air” LED on the transmitter will light up indicating the transmitter has been successfully detected and is now operational. You can now set the transmitting frequency by setting the “FREQ” DIP switch on the transmitter according to the following diagram.
Page 4 Problem: Distorted audio heard on the radio. Solution: Adjust the volume level on the addio player application and/or master computer volume. Manufactured by: UniKit Electronics Corporation #121 – 3823 Henning Drive Burnaby • BC • V5C 6P3 • Canada www.unikit.com...