Led Indicators - Axis M1065-LW User Manual

AXIS M1065-LW Network Camera
Hardware overview
SD card slot
NOTICE NO NO TICE TICE
• Risk of damage to SD card. Do not use sharp tools, metal objects or excessive force when inserting or removing the
SD card. Use your fingers to insert and remove the card.
• Risk of data loss and corrupted recordings. Do not remove the SD card while the product is running. Disconnect power or
unmount the SD card from the Axis product's webpages before removal.
This product supports microSD/microSDHC/microSDXC cards (not included).
For SD card recommendations, see www.axis.com
Control Button
For location of the control button, see Hardware overview on page 8 .
The control button is used for:
• Resetting the product to factory default settings. See page 64.
• Connecting to an AXIS Video Hosting System service. See page 53. To connect, press and hold the button for about 3
seconds until the Status LED flashes green.
• Connecting to AXIS Internet Dynamic DNS Service. See page 54. To connect, press and hold the button for about 3 seconds.
WLAN pairing button
The WLAN pairing button is used for connecting to an access point through push button configuration (PBC). For more information,
seeWireless Settings on page 56.

LED Indicators

Note
• The Status LED can be configured to flash while an event is active.
• The Status LED can be configured to flash for identifying the unit. Go to Setup > System Options > Maintenance.
Status LED
Unlit
Green
Amber
Amber/Red
Red
Indication
Connection and normal operation.
Shows steady green for 10 seconds for normal operation after startup completed.
Flashes green during wireless network pairing.
Steady during startup. Flashes during firmware upgrade or reset to factory default.
Flashes amber/red if network connection is unavailable or lost.
Firmware upgrade failure.
9