IDEAL IMAX XTRA E80 User Manual

IDEAL IMAX XTRA E80 User Manual

Advertisement

USER GUIDE
IMAX XTRA
E80 E120 E160 E200 E240 E280
For Installation Guide see reverse of book
When replacing any part on this appliance, use only spare parts that you can be
assured conform to the safety and performance specification that we require.
Do not use reconditioned or copy parts that have not been clearly authorised by Ideal.
For the very latest copy of literature for specification and maintenance practices visit our website
www.idealcommercialboilers.com where you can download the relevant information in PDF format.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the IMAX XTRA E80 and is the answer not in the manual?

Questions and answers

Summary of Contents for IDEAL IMAX XTRA E80

  • Page 1 Do not use reconditioned or copy parts that have not been clearly authorised by Ideal. For the very latest copy of literature for specification and maintenance practices visit our website...
  • Page 2: Electricity Supply

    Important Notes IMAX XTRA E • This appliance must not be operated without Natural Gas only the casing correctly fitted and forming an adequate seal. PI No. 86 CL 27 • Do not store objects around or on the boiler, and keep access clear at all times.
  • Page 3 BOILER CONTROLS / DISPLAY MASTER MODULE CONTROL PANEL A. Burner switch B. Pressure gauge C. Display D. Reset button RESET E. Mode button xtra F. Step button G. Store button H. + button (to increase STEP STORE MODE values) I. - button (to decrease values) im8219 Operation...
  • Page 4 CONTROL OF WATER TEMPERATURE AND SYSTEM TYPES The water temperatures and system types are factory preset but may be adjusted. The following settings can be changed. DHW Temperature (optional) DHW System CH System Flow Temperature Parameter settings and limits are listed below. Parameter mode is entered from standby mode by pressing the 'mode' button once.
  • Page 5: Frost Protection

    To shut Down the Boiler Condensate Drain 1. For short periods The condensate drain must not be modified or blocked. Set the external controls to OFF. Wait 10 minutes and then Blockage of the condensate drain, caused by debris or freezing, isolate the mains supply to the boiler.
  • Page 6 NOTES IMAX XTRA - Users...
  • Page 7 NOTES IMAX XTRA - Users...
  • Page 8 Ideal Boilers Limited pursues a policy of continuing improvement in the design and performance of its Ideal Consumer Helpline products. The right is therefore reserved to vary specification without notice. Tel: 01482 498376 Ideal is a trademark of Ideal Boilers. Registered Office;...

This manual is also suitable for:

Imax xtra e120Imax xtra e160Imax xtra e200Imax xtra e240Imax xtra e280

Table of Contents