Page 9
< • 8 " ! < # "*$ ° ° ° ° ; • " " " • 8 " " " Pour appropriate amount of hot water into Add appropriate amount of chemical to water solution tank in solution tank •...
Page 11
• & " > " " • 3 ° " • > <)6 K )6 ? " Chemical Feed Hose Connect the Auto-Fill Water Supply Hose to a faucet and turn on the water Connect the Auto-Fill Water Supply Hose to Solution Inlet (Male quick connect on the front of the machine.) 3/8”...
Page 12
" • > • 9 " • & " " " • 9 • • • K ! ! • & " " " " • & " " " " > " ! " Pump Prime Hose NM5080 Place end of prime hose and use Keep prime hose connected and run vacuum to prime the solution pump.
Page 13
'; ! # ! !& ! > & " Connect the male end of the HP Solution Hose Assembly to the female solution outlet fitting on HP Solution Hose Assembly – AH79D the machine. Connect the female end to the 1/4”...
Page 18
& Troubleshooting – Olympus M200H Problem Cause Solution Machine not Building circuit breaker tripped. Reset breaker or move cord to other outlet turning on - Faulty power cord Replace cord (AX32) No power Faulty switches or internal wiring Check wiring & test switches - Repair as needed * Solution Building circuit breaker tripped.
Page 19
Problem Cause Solution Pump-out Building circuit breaker tripped. Reset breaker or move cord to other outlet. not working Faulty power cord Replace cord (AX32) Check wiring & test switches - Repair as needed * Faulty switches or internal wiring (NM5008) Optional Pump-out pump faulty Replace pump-out pump (NM5053)
Page 20
Problem Cause Solution Solution Tank Water source turned off Turn on faucet or find other water source not filling Float not on valve arm Reconnect float to valve arm - Adjust to proper height/level Float valve faulty Repair or replace float valve (NM5055) Optional Water hose restricted Un-kink, clean out or replace hose...
Page 31
+ B# ! "& ! Direct the end of the prime hose into the recovery tank vacuum barb Vacuum acid solution out of Solution Tank > • ; Solution Tank 8 D 0...
Page 33
> 2 >L A 7> " " " " # !? 9 6 & ! ? # % " ? ? ; • 2 " " • . FLANGE FITTING Unless damaged or leaking between Remove four bolts holding valve tank and flange, the flange fitting does assembly to flange fitting not have to be removed...
Need help?
Do you have a question about the Olympus M200H and is the answer not in the manual?
Questions and answers