Bluesky CLT-789 Operating Manual

Cordless caller id phone

Advertisement

Quick Links

TROUBLESHOOTING

SYMPTOM
No dial tone
Check to see if the handset battery pack is connected inside the
handset battery compartment.
Make sure that the adaptor plug is connected to the base unit.
Check for the telephone line cord connections. Ensure that both
connectors are plugged securely on the jacks.
Test the phone at a different telephone wall jack and listen for a
dial tone.
Test a different phone in the wall jack and listen for a dial tone.
Will not ring
The phone or another phone connected to the same line may be
in the off-hook (IN USE) position.
Try a different phone, if the problem still exists, the fault is not
with the unit.
Static
The rechargeable battery pack might be weak. Allow the
rechargeable battery pack to charge fully before using.
Try a different phone, if the problem still exists, the fault is not
with the unit.
Some atmospheric conditions such as very low humidity can
cause static build-up.
Cannot dial
Press the TALK button on the handset and listen for a dial tone
out
before dialing out.
Are you in a rotary only area? Set the TONE/PULSE switch to
PULSE.
Try a different phone in the jack. If the problem persists, the fault
is not in the unit.
Is the phone connected to an answering machine? Disconnect
the answering machine and try to have the phone plugged into
the jack alone. If it works alone, there is a compatibility problem.
Purchase a 2 for 1 adaptor at any phone or electrical supply
store. Plug the 2 for 1 adaptor into the modular wall jack, and
then plug the phone into one side and the answering machine
on the other side of the adaptor.
Memory
Make sure that the unit is in the standby mode before storing a
feature does
phone number.
not work
The maximum number of digits that you can store for each
memory location is 32 digits. See the "Memory Dialing" section
for more details.
No link
You may have taken the handset at a distance away from the
between the
base that is beyond its normal operating range. Refer to the
base and
section of "Operating Range" in the manual for more details.
handset
15
SOLUTION
Operating Manual
CLT-789
Cordless Caller ID Phone
BLUEsky

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CLT-789 and is the answer not in the manual?

Questions and answers

Summary of Contents for Bluesky CLT-789

  • Page 1 • Memory Make sure that the unit is in the standby mode before storing a feature does phone number. CLT-789 • not work The maximum number of digits that you can store for each Cordless Caller ID Phone memory location is 32 digits. See the “Memory Dialing” section for more details.
  • Page 2 Your phone should be situated away from heat sources such as radiators, heaters, stoves or any other appliance that produces heat. Cleaning the Unit CLT-789 • Use a slightly damp cloth to clean the plastic cabinet. Never use polish, solvents, abrasives or strong detergents since these can damage the finish.
  • Page 3 3. BLOCK CALLS LOCATION OF CONTROLS You can set your phone in blocking call mode within desired times(from 1 to 12 hours), In standby mode, enter the digits as below: * * 5 ? # #, then press and hold the SET button 2 seconds. Note: ? means the digit from 0-9,* and #.
  • Page 4 Transferring calls (Base unit to cordless handset) During a phone conversation through the base unit, press HOLD button then the cordless handset number (1-4) on the base unit. The outside line will be on hold. Press any key of the cordless handset, then call will automatically transfer to the VOLUME cordless handset.
  • Page 5 Changing Stored Phone Numbers SAVE THESE INSTRUCTIONS Follow the steps described in “Storing Telephone Numbers into Memory.” IMPORTANT SAFETY The new phone number will automatically replace the previous one. INSTRUCTIONS Ringer Volume Control in Handset When using your telephone equipment, basic safety precautions should always be followed to In standby mode, press volume control button to adjust the ringer sound level either Hi or reduce the risk of fire, electric shock, and injury to persons, including the following: Low.
  • Page 6 If the product has been dropped or the cabinet has been damaged. Review and Redial a Dialed Number If the product exhibits a distinctive change in performance. Pressing “REDIAL/PAUSE” key of the handset or press “REDIAL/PAUSE ” key of the 13.
  • Page 7 NOTE: You can buy BLUEsky HS-999 Handset as your cordless handset extension. When inserting the battery into this product, the proper polarity or direction must be observed. Reverse insertion of batteries can cause charging that may result in leakage or explosion.
  • Page 8 (UP) Button - Used as UP function button in setting mode or CID browsing mode. Remove the battery compartment cover of the handset by pressing the top of the cover and sliding it down. BASE UNIT CONTROLS: Insert the battery pack into the battery compartment of the handset. Base Unit Antenna - Raise or reposition for best reception.

Table of Contents