VTech VSP736A Quick Start Manual page 10

Installing the phone
Make sure you plug in the Ethernet cable before powering up the phone.
1. If you plan to place the phone on a flat surface, attach the stand. Line up the
tabs on the stand with the slots on the rear of the phone. Two sets of slots
allow you to attach the stand at either a 45-degree or 35-degree angle. To
wall mount the phone, see the VSP736A Deskset User Guide.
2. Plug the end of the coiled handset cord into the jack on the side of the
telephone.
Handset cord jack
3. Plug one end of the Ethernet cable into the Ethernet port on the rear of the
deskset (marked by
network router or switch.
If the deskset is not using power from a PoE-capable network router or switch:
a. Connect a compatible VTech power adapter to the deskset power jack.
b. Plug the power adapter into an electrical outlet that is not controlled by a
wall switch.
IMPORTANT INFORMATION
1. Use only a compatible VTech power adapter (purchased separately from your
distributor or dealer).
2. The power adapter is intended to be correctly oriented in a vertical or floor
mount position. The prongs are not designed to hold the plug in place if it is
plugged into a ceiling, under-the-table or cabinet outlet.
If there is a networked computer and no extra Ethernet wall ports near the phone,
then the phone and PC can share the same network connection.
45°
), and plug the other end of the cable into your
35°
10