Before First Use - CDA FF852 Installation, Use And Maintenance Manual

Before First Use

You must allow the fridge to settle for at least twenty four hours
prior to switching the power on.
It is recommended that you clean the interior of the appliance prior to
first use, using a solution of bicarbonate of soda and warm water and
then thoroughly drying the interior.
The fridge may have an odour to it at first use. This will disappear as
the appliance cools.
The green power light on the control panel will be lit when you
have plugged the appliance into the power supply. Then turn the
thermostat dial to position 5 (coldest) and switch on the fast freeze
function until the red temperature warning light on the control panel
goes off.
When the red light has gone off, turn the thermostat down to the
required level (recommended between 2-4) and switch off the fast
freeze function.
Please note:
The appliance will work continuously until it comes down to the
correct temperature.
If the appliance is switched off, you should allow five minutes
before switching it on again to prevent unnecessary damage to the
compressor.
5