Summary of Contents for aquamanta TH 050
- Page 1 Titanium Heater TH 050/100/200/300/500 Instruction Manual...
- Page 2 Technical Information Aquarium Model Wattage Volume TH 050 TH 100 100W 100L TH 200 200W 200L TH 300 300W 300L TH 500 500W 500L • Before operating the appliance, please read this manual carefully and keep it properly for future reference.
- Page 3 4. A “drip loop” (see graphic) should be arranged for each cable connecting an aquarium to a power supply. The drip loop is the part of the cable below the level of the power supply. It prevents water travelling down the cable and coming into contact with the power supply.
- Page 4 10-15 minutes to allow it to cool, and then remove it from the aquarium. 3. A surge protector is recommended for all aquarium appliances. 4. Do not operate your Aquamanta heater when it is not fully submerged in water. 5. For indoor use only.
- Page 5 Troubleshooting HEATER DOES NOT WORK 1. Ensure the plug is inserted correctly and the switch is in the on position. THE LED IS WORKING, BUT THE HEATER IS NOT HEATING THE AQUARIUM 1. Check that the thermostat controller is set on the desired temperature.
- Page 6 1.0. Terms and Conditions of Guarantee. 1.1. Aquamanta warrants to the purchaser, for 2 Years from date of original purchase, to repair or replace goods where fault is found due to defective materials or faulty workmanship and where goods do not operate in accordance with the instructions.
- Page 7 Aquamanta, where permitted, will limit liability as follows and at Aquamanta’s option to: in regard to goods either a) the replacement of goods or supply of equivalent goods b) the repair of...
- Page 8 Manufactured in China Aquamanta and Kong’s are registered trademarks of Kong’s (Aust.) Pty Limited. www.aquamanta.com.au Instruction version: 08/05/2012...
Need help?
Do you have a question about the TH 050 and is the answer not in the manual?
Questions and answers