LG E2360S Service Manual page 14

E2360T (Analog&DVI)
Fig.1
Please check Manufacturer Name, Vendor Assigned Code, Monitor Name, Serial Number： *****[????????*****]
(it must be the same as Bar Code),Week of Manufacture： **,Year of Manufacture： ****,Checksum： ** (It must be
the same as the last byte of data table, as follows picture shows). Above of all must be right, then if it shows the
green "PASS", it means record succeeds ,the red "Fail" means record fails; Then check the power supply and
signal line, and ensure they are connected well ,then do DDC record again from the third step.
E2360S (Analog only)
Copyright © 2010 LG Electronics. Inc. All right reserved. - 14 - LGE Internal Use Only
Only for training and service purposes