Features
Small 3.5" Color LCD monitor is perfect for displaying rear camera images
Universal adhesive mount for windshield and A/C vent clip included
Invert Picture Up/Down, Invert Left/Right, & Brightness Adjustments
Anti-Glare coating on LCD screen
INSTALLATION TIPS:
Mounting:
For best viewing performance, try to mount this monitor in a location away from glare and
prevent direct sunlight from hitting the LCD screen.
The 3.5" LCD monitor may be small enough to mount on left side of dash for larger vehicles or
RV's. The left side is commonly where drivers first look at the left side mirror when backing
long vehicles. Mounting near the rear view mirror may also be possible. Having the LCD
monitor in an area near where the driver already looks helps to ease the transition from using
only mirrors to using a reverse camera AND mirrors.
Wiring:
We recommend connecting to the reverse light circuit in the vehicle and leaving the power
switch in the "on" position. This will allow the monitor to work automatically when backing
your vehicle. Make connections as shown in diagram on page 2. If you connect the monitor
to a Switched +12V power source, then you must manually turn the monitor on and off when
backing. (Not recommended)
Do not run cables near sources of high-volt noise or interference.
SPECIFICATIONS:
Size: 3.75 x 3.0 x 1.25"
(95 x 76 x 31mm)
Weight: Oz. (59 G)
Screen Size: 3.5" Diagonal w/
Anti-glare coating
Pixels: 600 (H) x 234 (V)
Resolution: Up to 140,400 pixels
SecurView SV-8500 Mini 3.5" Color LCD Monitor
Installation Guide
TECH SUPPORT: (800) 998-6880
Image Controls: Invert Up/down
Invert Left/Right
Brightness Adjust
NTSC or PAL signal
Video Output: 1.0 V P-P composite (75 Ohm load)
Supply Voltage: +12VDC
Mounting: Magnetic/Suction Flex Mount or Air Vent Clip