Getting Started; Inserting Batteries; Finding Your Viewing Channel; Setting Up Progressive Scan Feature - Toshiba SD-270EKB Owner's Manual

Inserting Batteries
A Open the battery compartment.
B Insert two batteries type R03 or AAA, following the
indications (+ / - ) inside the compartment.
C Close the cover.
CAUTION!
-Remove batteries if they are exhausted
or if the Remote Control is not being used
for a long time.
-Do not use old and new or different types
of batteries in combination.
-Batteries contain chemical substances,
so they should be disposed properly.
Using the Remote Control to Operate
the System
30
Within about 6m (19 feet)
OPEN/CLOSE DISPLAY
1
4
7
+10
A Aim the Remote Control directly at the remote sensor
MENU
(IR) on the front panel.
RETURN
F.R F.F
B Do not put any objects between the Remote Control
STEP PLAY/PAUSE
REPEAT A-B
and DVD Player while operating the DVD Player.
SUBTITLE ANGLE
RANDOM PROG
S E -R 0268
Finding your viewing channel
I/
A Press
2ON/STANDBY on the DVD player to turn it
on.
B Turn on the TV and set it to the correct video-in
channel. You should see the blue DVD background
screen.
Usually these channels are between the lowest
and highest channels and may be called FRONT,
A/V IN or VIDEO. See your TV' s manual for more
details.
Or, you may go to channel 1 on your TV, then
press the Channel down button repeatedly until you
see the Video In channel.
Or, the TV remote control may have a button that
Helpful hint: Press  to go back to previous menu item.
Press SETUP to exit the menu item.
30
ON/STANDBY
2 3
5
6
8 9
T-SEARCH
0
SETUP
OK
TITLE
PREV NEXT
STOP
SLOW CLEAR
AUDIO ZOOM
Getting Started
chooses different video modes.
Or, tune the TV until you can see the signal from
the RF modulator (refer to your TV user manual).
C If you are using external equipment, (such as
audio system or receiver), turn it on and select the
appropriate input source for the DVD player output.
Refer to the equipment user's manual for detail.
Setting up Progressive Scan feature
(for Progressive Scan TV only)
The progressive scan display twice the number
of frames per seconds than interlaced scanning
(ordinary normal TV system). With nearly double
the number of lines, progressive scan offers higher
picture resolution and quality.
Before you start...
-Ensure that you have connected this DVD player to
a progressive scan TV using the Y P
( see page 7).
-Ensure that you have completed the basic installa-
tion and set up.
A Turn on your TV and select the video input
connected to the DVD video player (refer to your TV
user manual).
I/
B Press
2ON/STANDBY on the remote control to
turn on the DVD player.
The blue DVD background screen will appear on
the TV.
C Press SETUP.
D Press / to select { Video }, then press .
E Press / repeatedly to select { Video Out }, then
press .
F Select { P- Scan }, then press OK to confirm.
The menu will appear on the TV.
Activating Progressive Scan
1.Ensure your TV system supports
Progressive Mode
2.If there is a distorted picture on
the TV, wait 15 seconds for
automatic recover
No
Yes
G Press  to highlight { Yes } and press OK to confirm.
 The reconfirmation menu will appear on the TV.
P connection
B R