B&C Eagle US5016LMA Operation And Maintenance Manual

Fine wire auto stapler

Hide thumbs

Table Of Contents

Quick Links

US5016LMA

FINE WIRE AUTO STAPLER

OPERATION and MAINTENANCE MANUAL

BEFORE OPERATING THIS TOOL, ALL OPERATORS SHOULD STUDY THIS

MANUAL TO UNDERSTAND AND FOLLOW THE SAFETY WARNINGS AND

INSTRUCTIONS. KEEP THESE INSTRUCTIONS WITH THE TOOL FOR FUTURE

REFERENCE.

YOU

HAVE

ANY

QUESTIONS,

CONTACT

YOUR

REPRESENTATIVE OR DISTRIBUTOR.

Table of Contents

Need help?

Do you have a question about the US5016LMA and is the answer not in the manual?

Questions and answers

Summary of Contents for B&C Eagle US5016LMA

Page 1 US5016LMA FINE WIRE AUTO STAPLER OPERATION and MAINTENANCE MANUAL BEFORE OPERATING THIS TOOL, ALL OPERATORS SHOULD STUDY THIS MANUAL TO UNDERSTAND AND FOLLOW THE SAFETY WARNINGS AND INSTRUCTIONS. KEEP THESE INSTRUCTIONS WITH THE TOOL FOR FUTURE REFERENCE. HAVE QUESTIONS, CONTACT YOUR REPRESENTATIVE OR DISTRIBUTOR.
Page 2: Table Of Contents
INDEX Safety Instructions ..........3, 4 Air Supply: Fittings, Hoses, Filters, Air Consumption, Regulators, Operation Pressure, Setting Correct Pressure .
Page 3: Safety Instructions
SAFETY INSTRUCTIONS EYE PROTECTION which conforms to ANSI specifications and provides protection against flying particles both from the FRONT and SIDE should ALWAYS be worn by the operator and others in the work area when connecting to air supply, loading, operating or servicing this tool.
Page 4 AIR SUPPLY AND CONNECTION Do not use oxygen, combustible gases, or bottled gases as a power source for this tool as tool may explode, possibly causing injury or death. Do not use supply sources which can potentially exceed 200 P.S.I.G. as tool may burst, possibly causing injury.
Page 5: Air Supply: Fittings, Hoses, Filters, Air Consumption, Regulators, Operation Pressure, Setting Correct Pressure
AIR SUPPLY AND CONNECTIONS Do not use oxygen, combustible gases, or bottled gases as a power source for this tool as tool may explode, possibly causing injury. Keep the tool pointed away from yourself and others when connecting air source. FITTINGS: Install a male plug on the tool which is free flowing and which will release air pressure from the tool when disconnected from the supply source.
Page 6: Production Specifications
PRODUCT SPECIFICATIONS DRIVING POWER ..............55 in.lbs FASTENER TYPE .
Page 7: Loading The Tool
LOADING TO PREVENT ACCIDENTAL INJURIES: • Never place a hand or any other part of the body in nail discharge area of tool while the air supply is connected. • Never point the tool at anyone else. • Never engage in horseplay. •...
Page 8: Tool Operation
TOOL OPERATION EYE PROTECTION which conforms to ANSI specifications and provides protection against flying particles both from the FRONT and SIDE should ALWAYS be worn by the operator and others in the work area when connecting to air supply, loading, operating or servicing this tool.
Page 9: Maintaining The Pneumatic Tool
MAINTAINING THE PNEUMATIC TOOL When working on air tools, note the warnings in this manual and use extra care evaluating problem tools. CAUTION: Pusher spring (constant force spring). Caution must be used when working with the spring assembly. The spring is wrapped around, but not attached to, a roller. If the spring is extended beyond its length, the end will come off the roller and the spring will roll up with a snap, with a chance of pinching your hand.
Page 10: Troubleshooting
TROUBLE SHOOTING PROBLEM CAUSE CORRECTION Frame/nose leaks air Loose nose screws ....Tighten and recheck O-ring or Gasket is cut or cracked . . .Replace O-ring or gasket Bumper cracked/worn .
Page 11 -11-...