CrimeStopper CS-9701 Gargoyle Owner's Instructions

CRIMESTOPPER SECURITY PRODUCTS CS-9701

Wiring

Main Harness: 10 pin 18 gauge wires
Red Wire: +12Volt Power
Connect to constant +12volt power source with supplied in line 10 amp fuse and fuse holder.
Black Wire: Chassis Ground
Connect to body metal of the vehicle using a sheet metal screw.
Yellow Wire: Ignition Switched "ON" and "START" +12Volts
Connect to an Ignition Wire (or fuse in the fuse box) that shows +12Volts when the key is in both the
"ON" and "START" positions.
Orange Wire: (-) Negative Starter Disable Output (optional)
This wire is connected to terminal 85 of a relay for the starter disable. Connect terminal 86 to the Yellow
ignition switched wire. Cut the vehicle starter wire. Connect one half to terminal 30 and the other half to
terminal 87a.
White Wire: +12Volts Flashing Parking Light Output (optional)
Connect to any parking light or to the parking light output at the back of the headlight switch. ! ! ! DO
NOT CONNECT TO DASH DIMMER CIRCUIT ! ! !
Brown Wire: + Siren Output
Connect brown wire to siren red wire. Connect black wire of siren to chassis ground (body metal).
Blue Wire: (-) Hood/Trunk Pin Switch Input
Connect to pin switches which go to ground when hood and trunk are opened. It may be necessary to
install your own switches.
Green Wire: (-) Door Pin Switch Input
Connect to door switches which go to ground when door is opened. A (-) negative door switch wire will
read +12 volts when doors are closed.
Violet Wire: (+) Door Pin Switch Input
Connect to door switches which go to +12 volts when door is opened. A (+) positive door switch wire will
read (-) ground when doors are closed.
Gray Wire: (-) Negative Remote Output (optional, requires relay)
Connect to terminal 85 of relay. Connect terminal 86 to +12Volts constant. Connect terminal 87 to
+12volt constant or (-) ground. Connect terminal 30 to device to be activated.
Sensor Plug: 4 Pin 22 Gauge
White Wire - Negative Warn Away
Blue Wire - Negative Trigger
Black Wire - Sensor Ground
Red Wire - Sensor +12Volt Power
The sensor supplied with this system requires no additional wiring. Simply mount the sensor in a suitable
location and plug it in. Adjust sensitivity as necessary.
LED and Override/Valet Switch Plug: 2 Pin 22 Gauge
Connect LED plug to Red Connector on module and connect Override/Valet plug to Blue connector on
module.