Panasonic TH-P42ST30D Operating Instructions Manual page 29

Charging the 3D Eyewear (rechargeable type)
(TH-P42ST30M, TH-P42ST30P, TH-P50ST30M, TH-P50ST30P: supplied)
(TH-P42ST30D, TH-P42ST30T, TH-P42ST30V, TH-P50ST30D, TH-P50ST30K, TH-P50ST30T,
TH-P50ST30V
To charge when the TV is in the Standby mode
MENU
TV
To charge when the TV is on
1. Turn off the television power, and set the 3D Eyewear power switch to "OFF"
2. Connect as shown above, and turn on the television power
•
The indicator lamp of the 3D Eyewear lights red, and charging starts.
•
When the indicator lamp turns off, charging is complete. (Approximately 2 hours required)
3. Turn off the television power, and remove the charging cable
Storage and Cleaning
(for the supplied 3D Eyewear: TH-P42ST30M, TH-P42ST30P, TH-P50ST30M, TH-P50ST30P)
•
Clean using a soft, dry cloth.
Wiping the 3D Eyewear with a soft cloth that is covered in dust or dirt may scratch the eyewear. Shake
off any dust from the cloth before use.
•
Do not use benzene, thinner, or wax on the 3D Eyewear, as doing so may cause the paint to peel off.
•
Do not dunk the 3D Eyewear in liquid such as water when cleaning.
•
Avoid storing the 3D Eyewear in hot or highly humid locations.
•
During the long period of disuse, full charge the 3D Eyewear once every 6 months to keep the battery
performance.
Note
•
As the liquid crystal shutters (lens) are fragile and easily broken, be very careful when cleaning them.
28
"Optional accessories" (p. 8))
1. Display the menu
MENU
"How to Use the Menu Functions" (p. 34)
2. Select [Setup]
3. Select [Other Settings]
System Menu
Other Settings
4. Select [USB Charge in Standby] and set [On]
Other Settings
USB Charge in Standby
Power Save
5. Turn off the television power, and set
the 3D Eyewear power switch to "OFF"
6. Connect as shown
7. Remove the charging cable
2/2
Access
Off
On
USB connector
Mini USB connector
select
access
select
[USB Charge
in Standby]
access
•
The indicator lamp
lights red, and
charging starts.
•
When the
indicator lamp
turns off, charging
is complete.
(Approximately 2
hours required)
select
[On]
store