Do you have a question about the BQ06042-1 and is the answer not in the manual?
Questions and answers
Summary of Contents for Member's Mark BQ06042-1
Page 1
Grill Guide For Model BQ06042-1 Professional Liquid Propane Gas Island Grill Stop! Missing a part? No need to go back to SAM'S CLUB! SAM'S CLUB does not stock parts for this item at the Club, but our grill team is here to help you.
THIS GRILL IS FOR OUTDOOR USE ONLY. If stored indoors, then detach and leave propane cylinder outside. TO THE INSTALLER OR PERSON ASSEMBLYING THIS GRILL: Leave this Grill Guide with the consumer. TO THE CONSUMER: Retain this Grill Guide for future reference. Safety Precautions Always read and follow all DANGER, WARNING, AND FOR YOUR SAFETY notices in this Grill Guide.
General Information and Operation………………..………………………………..14-24 Trouble Shooting Guide………………………………………………....……..25 Frequently Asked Questions……………………………………………………………26 Write down here and keep for future reference BQ06042-1 Date of Purchase: _________________ Retailer : Serial Number: ___________________ The serial number may be found on the placard located Address : on the back of the grill Visit us at: www.samsclub.com...
Limited Warranty The manufacturer warrants to the original This limited warranty does not cover the cost of consumer-purchaser that this product shall be any inconvenience or property damage due to free from defects in workmanship and materials failure of the product and does not cover damage under normal reasonable...
.6.) Do not use a Power Screwdriver for assembly as you could strip the threads on the Nuts and Bolts. .7.) The propane tank for this grill is sold separately. See the LP Gas and Cylinder Information later in this guide. BQ06042-1 WARNING Failure...
Page 6
BQ06042-1 Detail Parts List 1 Thermometer 36 “U” Main Burner 77Silicon Stopper for Countertop 2 Silicon Stopper For Hood 37 Heat Shield-Control Panel Inner 78Left Side Table 79 Decorative Panel 3 Hood Bolt 38 Burner Support Rail 80Cabinet Left-Top-Back Panel...
Page 8
BQ06042-1 Assembly Parts List Small Cooking Grate…2PCS Heat Diffuser ---3 PCS Warming Rack --- 1 PC Towel Bar Handle-----2 PCS Large Cooking Grate...1PC 4. Rotisserie Spit with 5.Meat Fork - 2 Pcs 6.Counterweight - 1 Pc 7.Rotisserie Handle..…1PC Motor -1Pc BQ06042-1 Assembly Hardware List A.
Page 10
STEP 3 – Insert the 3 Cooking Grates into the firebox. There are 2 small and 1 large cooking grates. They can be inserted in any order. STEP 4 – Insert the Warming Rack into the upper sides of the firebox. Be sure the sides of the warming rack fit down into the slots to secure it in place.
Page 11
STEP 5 – Slide the Rotisserie Motor onto the mounting bracket on the right side of the firebox sidewall. Note: We recommend you store the Rotisserie Motor in one of the drawers when not in use. Do not use the Rotisserie Motor in rain or expose to moisture. STEP 6 –Assemble the Rotisserie Spit in the following order.
Page 12
STEP 7 – Slide the Spit Assembly into place by inserting the pointed end into the rotisserie motor (Insert 2) and placing the bushing into its bracket on the left firebox sidewall (Insert1). Note: We recommend you store the counterweight and Forks in a drawer when not in use. A holder is located on the back of the firebox for Spit storage.
Page 13
STEP 9– Remove any labels and additional packing material from the grill except CSA Label. Be sure to clean all foam packing material out of all areas. Congratulations! Your grill is now fully assembled. Please proceed and read the General Information and Operation portion of the Grill Guide before attempting to hook up the LP gas cylinder or operating your grill.
General Information and Instructions Your new Member’s Mark Island Grill has been designed and manufactured to high quality standards. It will provide you with many years of enjoyment with a minimal amount of maintenance. Please keep in mind the following FOR YOUR SAFETY. OPERATION 1.
Page 15
LP CYLINDER FILLING AND EXCHANGE Some areas only allow you to exchange your empty cylinder for a replacement that is already full. Other areas allow you to refill your cylinder. If you are in an area where you can refill your cylinder: 1.
Page 16
TRANSPORTATION AND STORAGE 1. Place dust cap on cylinder valve outlet whenever the cylinder is not in use. Only install the type of dust cap on the cylinder valve outlet that is provided with the cylinder valve. Other types of caps or plugs may result in leakage.
Page 17
The regulator must enter the cylinder valve in a straight line. Center this nipple of the regulator into the cylinder valve. WARNING Always keep the gas cylinder in the Q.C.C.1 Type 1 Connector upright position all the time WARNING 1. Do not connect this grill to any unregulated sources of propane. 2.
Page 18
Grill Placement ! FOR YOUR SAFETY! 1. Minimum clearance required from sides and back of unit to adjacent combustible construction is 24 inches (61 cm). 24"(61cm) 2. Do not locate or use this outdoor cooking gas appliance under overhead combustible surfaces. Keep any electrical supply cord and the fuel supply hose away from any heated surfaces and water.
Page 19
MANUALLY LIGHTING THE MAIN BURNERS WITH THE MATCH HOLDER 1. Open the lid. 2. Ensure all burners are in the “Off” position. 3. Slowly turn on the gas at the LP cylinder valve if it is not already on. 4. Place a match in the Match Holder. This is located in the top center drawer of the grill cabinet underneath the right main burner.
Page 20
for 5 to 7 seconds after the burner lights until the flame sensor begins operating. Letting up on the burner control knob before a high enough temperature has been reached may cause the flame sensor to shut off fuel to the back burner. 9.
Page 21
CLEANING THE BURNERS 1. Ensure the natural gas is turned off at the shutoff valve. 2. Remove the cooking grates, heat diffusers, and grease tray. 3. Remove the Phillips Head screws located at the back end of each burner. 4. Lift each burner up and out. 5.
Page 22
GRILL STORAGE 1. Clean your grill before storage. 2. Storage of a gas grill indoors is permissible only if the cylinder is disconnected and removed from the gas grill. 3. Cover the grill. 4. Perform a Leak Test before use after storage. Grilling With Your New Grill Welcome to the world of grilling.
Page 23
WARNING 1. Do not operate your Rotisserie Motor in the rain, or expose it to moisture. Store it in a dry place when not in use. 2. Keep any electrical supply cord and fuel supply hose away from any heated surfaces. 3.
Page 24
HELPFUL HINT You can reduce the strength of the smoke flavor by only smoking for half or three quarters of the cooking time. The heat required for smoking is normally low to medium. KNOWING WHEN THE FOOD IS DONE We strongly recommend using a meat thermometer. Food cooked on a grill can brown very fast on the outside, well before it’s cooked on the inside.
Trouble Shooting Guide BURNER WILL NOT LIGHT 1.) Gas supply is turned off. Turn on gas at LP cylinder. 2.) Out of propane. Check to be sure you still have propane in your tank. 3.) Regulator is not properly seated into the tank valve. Remove and reattach. Hand tighten only. 4.) Crimped fuel supply hose.
3.) Gas is leaking from a faulty connection or damaged hose. Perform a leak test and inspect for leaks. Tighten or replace parts as necessary. Frequently Asked Questions Can I convert my gas grill from one fuel source to another? No.
Need help?
Do you have a question about the BQ06042-1 and is the answer not in the manual?
Questions and answers