Table of Contents
Advertisement
3. T T e e s s t t i i n n g g S S e e n n s s o o r r —Use the heel of the palm of your hand to strike the door pillar of the car after
any increase or decrease in adjustment. The siren will chirp once if the impact was great enough to
generate a full trigger. Pre-warn level is set automatically. When desired setting is reached, sensor
adjustment mode can be exited.
Exit Shock Sensor Adjustment Mode
The adjustment mode will be exited if:
➤ ➤
No input from transmitter for 15-seconds.
➤ ➤
No input from sensitivity testing for 15-seconds.
➤ ➤
The ignition is turned On.
➤ ➤
The Valet button is pressed.
The siren will emit 1 long chirp and the LED will extinguish which shock adjustment mode is
exited.
Reset Shock Sensor to Default Setting
The shock sensor can be restored to a default setting of 10 to facilitate re-adjustment at any time
while in adjustment mode.
1. Simultaneously press the
2. The system will emit 3 chirps to indicate the sensor has been reset to level 10.
3. The system returns to shock sensor adjustment mode for further adjustment, if required.
Diagnostics
The system's microprocessor monitors and reports all active and violated zones when arming and
disarming. LED flashes indicate the active or violated zone; siren chirps indicate system status.
Arm/Disarm Diagnostics
The number of siren chirps will indicate the status of the system when arming and disarming. For
information on which zone is active or has been violated refer to the Table of Zones.
2006
©
Directed Electronics
and
buttons.
37
Hide quick links:
Advertisement
Table of Contents
