Advertisement
Quick Links
Advertisement
Summary of Contents for skyangel A-4F
- Page 1 Assembly and Operating Manual...
- Page 2 Assembly and Operating Manual A-4F Dear customer, To fly the A-4F you will need a radio control system Foam safe epoxy is recommended and available Congratulations on your choice of a with at least four channels. 2.4GHz radios systems from most reputable model retail shops.
-
Page 3: Parts Illustration
Assembly and Operating Manual A-4F Fig. 1 Open the box and check all the parts. Parts Illustration Parts List Description Fuselage Wing Set – One Main Wing Panel Tail Set - One Left (and one Right) Horizontal Stabilizer with Elevator... - Page 4 Assembly and Operating Manual A-4F Fig. 2 - Assemble the main wing panel to the Fig. 3 - Attach the white fix base as photos shown. Fig. 4 - Tighten the main wing with screws. fuselage (glue not included). Fig. 5 - Photo shows the finished view after the Fig.
- Page 5 Assembly and Operating Manual A-4F Fig. 8 - Photo shows the finished view after the Fig. 9 - Locate the fixed plate for the front wheel. Fig. 10 - Glue the fixed plate into the fuselage as rear wheels attached.
- Page 6 Assembly and Operating Manual A-4F Fig. 14 - Attach the vertical stabilizer to the Fig. 15 - Remove any excess glue and hold in Fig. 16 - Glue the horizontal stabilizers to the slots fuselage. position until the glue sets. The photo shows the at the vertical stabilizer (glue not included).
- Page 7 Assembly and Operating Manual A-4F Fig. 20 - Glue missiles into the main wing slots Fig. 21 - Photo shows missiles in attached position Fig. 22 - Connect the electronic speed controller (glue not included). and servos to the receiver. Refer to the radio instructions for the correct channel sockets and servo lead polarity.
- Page 8 Assembly and Operating Manual A-4F Fig. 26 - The canopy is held in place by magnets and can be lifted off. Fig. 27 - Congratulations, you have completed the assembly process. We hope you enjoy flying your new model! Fig. 28 - Charge the flight battery; connect the Equalizer lead using and Fig.
- Page 9 Assembly and Operating Manual A-4F Fig. 30 and 31 - Checking Ailerons and Elevators - Check that the control surfaces respond to the appropriate movements of the transmitter sticks. If not, swap over the connectors at the receiver. - Check the neutral position of the control surfaces; you may need to screw the clevises in or out to correct any discrepancy.
- Page 10 Assembly and Operating Manual A-4F Fig. 33 - Checking the model’s balance - Place the flight battery in its compartment, without connecting. - Mark the Centre of Gravity (CG) on both sides of the fuselage; the position is shown in the photo.
- Page 11 Switch the motor on, and launch the airplane strongly into the wind, with the fuselage and wings level. Allow the A-4F Jet to fly straight and level initially; don’t try to turn it when it is close to the ground.
- Page 12 Jiangyin Skyangel Electronic Technology Co., Limited. 5th Floor, A3 Building, Xinjianxing Technology Industrial Park, Fengxin Road, Guangming Town, Bao'an, Shenzhen City, 518107 China Phone: +86 755 33699201 Fax: +86 755 33699203 www.skyangelrc.com...
Need help?
Do you have a question about the A-4F and is the answer not in the manual?
Questions and answers