Troubleshooting; Environmental Specifications - Sharp LC-32LD164E Operation Manual

Appendix

Troubleshooting

Problem
No picture
Abnormal colours
Twisted picture
Picture too dark
Audio only, no images
Picture only, no audio
Cannot use remote control
Cannot receive sufficient channels
through antenna
No colour
Blinking picture accompanied by ghost
image
Broken lines or segments
Certain TV channels are blocked (Hope
to acquire some channels)
Overlapping images or ghost images
Cannot use a function
Cannot receive programmes

Environmental specifications

Item
*1 On-Mode (W)
*2 Energy-Save-Mode (W)
*3 Standby-Mode (W)
*4 Annual Energy Consumption (kWh)
*5 Annual Energy Consumption (kWh)
(Energy-Save-Mode)
6 Energy Classification
*1 Measured according to IEC 62087 Ed� 2 / Ed� 3
*2 For further information about the Energy Save function, please see related pages in this operation manual
*3 Measured according to EN 50564: 2011
*4 Annual energy consumption is calculated on the basis of the On-Mode (Standard) power consumption, watching TV 4
hours a day, 365 days a year
*5 Annual energy consumption is calculated on the basis of the Energy-Save-Mode power consumption, watching TV 4
hours a day, 365 days a year�
NOTE
• The power consumption of On-Mode varies depending on the images the TV displays�
12 -
Possible Solution
1� Connect power cord correctly�
2� Turn on power�
3� Connect signal cable correctly�
4� Press any button on the LCD TV�
Connect signal cable correctly�
1� Connect signal cable correctly�
2� Please use compatible signal�
Adjust brightness and contrast�
1� Please check if input signal is connected correctly�
2� TV-RF signal must not be lower than 50dB�
1� Connect signal cable correctly�
2� Adjust volume to proper level�
3� Connect audio signal cable correctly�
4� TV-RF signal must not be lower than 50dB�
1� Please change battery�
2� Turn off power for 10 seconds; and then restart power�
Please use the Channel Scan function to increase the number of channels not
included in memory�
Please adjust the colour setup�
1� Check the connection of antenna/signal cable�
2� Check if channel is in play mode�
3� Press signal source and change input mode�
Adjust antenna�
Keep the TV away from noise sources, such as automobiles, neon lights, and
hair dryers�
Please use the Update Scan method to add the channels not included in
memory�
Please use multi-directional outdoor antenna�
(If your TV is subject to the influence of nearby mountains or buildings)�
If the item you choose turns gray, that item cannot be selected�
Please use the Update Scan method to add the channels not included in
memory�
32"
Standard 40W
Eco > On 32W
0�26W
58kWh
Eco > On 46�8kWh
Class A
42" 46" 50"
68W 69W 83W
54W 55W 67W
0�28W 0�28W 0�28W
99kWh 101kWh 121kWh
79kWh 81kWh 98kWh
Class A Class A Class A