Page 2
Overview The purpose of this document is to familiarize you with the DS91M125 evaluation board, suggest the test setup procedures and instrumentation, and to guide you through some typical measurements that will demonstrate the performance of the device. The board enables the user to examine performance and all functions of the DS91M125 as a standalone device.
Page 3
3. Enable one of the U2 driver outputs. This is accomplished by setting the DE0-3 pin to VDD (JP3-6). 4. Connect a signal source to the driver input (DI+, DI-). The signal needs to be an LVDS/M- LVDS/CML/LVPECL compliant signal. Refer to the DS91M125 datasheet for the receiver input compatibility.
Page 4
Figure 3 shows an eye diagram acquired at the output of the DS91M125 driver loaded with a 100-ohm resistor. The generator connected to the driver input simulated a 100 Mbps PRBS-7 NRZ. Figure 3 – DS91M125 Output August 11, 2008 Rev.
IMPORTANT NOTICE Texas Instruments Incorporated and its subsidiaries (TI) reserve the right to make corrections, modifications, enhancements, improvements, and other changes to its products and services at any time and to discontinue any product or service without notice. Customers should obtain the latest relevant information before placing orders and should verify that such information is current and complete.