Specifications - Peavey Rage 258 Transtube Series Operating Manual

8 LOW, MID AND HIGH EQ
Passive tone controls that regulate the low, mid and high frequencies, respectively.
HEADPHONE JACK
9
This stereo jack allows signal to flow to both sides of any stereo headset. A monaural headset
may be used, but it is not recommended.
10 POWER LED
Illuminates when power has been supplied to the unit.
11
POWER SWITCH
Press the switch to the "ON" position to apply power to the unit. The POWER LED (10) will
illuminate to indicate power has been supplied to the unit.
12
AC POWER CORD (REAR PANEL)
12
This line cord provides the AC power to the unit. Connect the line cord to a properly
grounded AC supply. Damage to the equipment may occur if improper line voltage is used.
(See voltage marking on unit.) Never remove or cut the ground pin of the line cord plug.
NOTE: FOR UK ONLY
As the colors of the wires in the mains lead of this apparatus may not correspond with the colored
markings identifying the terminals in your plug, proceed as follows: (1) The wire which is colored
green and yellow must be connected to the terminal which is marked by the letter E, or by the earth
symbol, or colored green or green and yellow. (2) The wire which is colored blue must be connected
to the terminal which is marked with the letter N, or the color black. (3) The wire which is colored
brown must be connected to the terminal which is marked with the letter L or color red.

Specifications

POWER AMP SECTION
Rated Power:
25 W(rms) into 8 Ω
Power @ Clipping (Typically):
(5% THD, 1 kHz, 120 V AC line)
25 W RMS into 8 Ω
Rated Consumption:
50 W, 50/60 Hz, 120 V AC
PRE AMP SECTION
The following specs are
measured @ 2 kHz with the
controls preset as follows:
Channel Select Normal (OUT)
Low and High @ 10
Mid @ 0
Pre Gain and Post Gain @ 10
Preamp Input
(Normal Channel)
Impedance: High Z, 1 M Ω
Nominal Input Level: -6 dBV
70 mV RMS
Aux Input:
Input Impedance: 100 k Ω
Nominal Input Level: .5V RMS,
-6 dBV
(Stereo jack designed for use
with stereo headphone output on
CD/Tape Player)
Headphone Output:
Load Impedance: 8 Ω
Nominal Power Output:
50 mW into 8 Ω
Specifications subject to change without notice.
:
(Stereo jack, monaural signal
disconnects internal speaker
when phone plug is inserted.)
Equalization:
Special low, mid, and high
passive type EQ
Dimensions (H x W x D):
14.75" x 16.25" x 8.5"
37.47 cm x 41.27 cm x 34.80 cm
Weight:
17.8 lbs.
8.07 kg